Lead Dynamic NL Bedienungsanleitung Seite 4

ENGLISH
Thank you for choosing a product from LEAD energy
AG. If you would like to get in touch with our service
team, please contact them via our website or by
e-mail.
Intended use
You can attach the LED MOTION NIGHT LIGHT sets
to walls, ceilings or furniture to generate continuous
bar lighting. The motion sensor (PIR sensor) will
switch your lighting on for approx. 150 seconds.
Danger
Always only operate the LED MOTION NIGHT LIGHT
in an unwound state. Operating the LED MOTION
NIGHT LIGHT in a wound state may lead to irrepa-
rable damage.
LEAD ENERGY AG Am Stadtbad 37 45219 Essen-Kettwig
Note
Please observe the warnings prior to installation.
1.1
Remove dirt, grease and other residue from the sur-
face on which you want to mount your LED MOTION
NIGHT LIGHT before installation. Peel the protec-
tive film away from the adhesive strip and position
the LED strip in the required place applying light
pressure.
1.2
Align your sensor so that its detection range of approx.
90 degrees covers the area in which movement is to
be registered. Your sensor must be mounted such
that there are no obstacles in the field of vision.
Subject to errors and amendments
?
service@lead-energy.com
www.lead-energy.com
Mounting of LED strip
Mounting the sensor
Information / Technical support: www.lead-energy.com