Herunterladen Inhalt Inhalt Diese Seite drucken

Dmx Wiring - MediaLas Spooky Blue V4 Betriebsanleitung

Dmx laser projektor
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

2 Installation
2.1 Interlock and emergency stop
For laser safety each Spooky Blue Laser Projector has an interlock
connector, which cuts of the power supply of the laser. In order to use
this function you will need an external emergency stop button and/or key
switch, which can be ordered separately. The cable length to the interlock
can be up to 100m. As long as the interlock connector is open, no laser
output is possible. On the interlock wires, 12V DC is pending. Therefore,
several interlocks cannot be paralleled.
For testing purposes you will find a service plug supplied with the
projector. With this plug you can temporarily enable laser output while
testing. Do not use for normal operation.
2.2 Rigging
WARNING! Always keep a distance of 1m to the wall or to inflammable
objects. Always keep the minimum distances for laser safety.
The unit can be mounted on rigging using a C-mount bracket. Additionally, a
safety rope is recommended.

2.3 DMX wiring

For DMX signal use shielded twisted pair cables. We suggest DMX cables,
standard signal lines can also be used. Standard 3 pin XLR connectors are
used.
Pin-out:
Pin 1:
ground (shield)
Pin 2:
DMX – (blue)
Pin 3:
DMX + (red)
The DMX signals are internally bridged, so that the Spooky can be chained
into existing DMX environment. When connecting to 5 pin DMX lines pins 4
and 5 are not connected. Always check for the correct polarity of the DMX
signals, otherwise the Spooky will not function correctly.
2.4 Connecting mains
When connected to DMX, Spooky can be connected to the mains supply. Make
sure that at least 50VA power are available.
Connect mains only when the Spooky is completely assembled. When connecting
an open device to mains you risk a deadly electrical shock. The device is
for indoor use only.
If in doubt consult a technician. The manufacturer shall not be held liable
for any damage when the device is improperly connected or installed, or not
operated according to this manual.
Spooky Blue V4 Laser Projektor
14

Quicklinks ausblenden:

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis