Initial Set-Up; Settings For Connecting To The Home Network; Tuning Channels - Grundig Rio 49 Clx 7745 Ap Kurzanleitung

INITIAL SET-UP

The television set is fitted with an "installation
assistant", which guides you step by step
through the basic settings.
Using the screen dialogue, the user guide
enables supposedly complex settings and data
entries to be presented simply and clearly for
everybody.
Pages and dialogue items appear on the
screen, which identify the subsequent and likely
operating steps.
To support this, you will also see the required
button symbols of the remote control.
The basic settings in detail:
– language selection
– country selection;
– choice of user mode;
– location selection;
– accessories selection;
– network settings (if desired);
– Station settings (DVB-S, DVB-T, DVB-C and
analogue channels).
The detailed settings can be found on pages 20
and 23.
Settings for connecting to the
home network
Depending on the connection to the home
network, you connect your television to the
home network:
– via a LAN connection or
– without cable via WLAN
There are two options with the LAN-connection:
Automatic connection
all data regarding connection settings
(»IP Address«, »Netmask«, »Gateway«
and »DNS«) are obtained from modem
automatically.
Manual connection
all data regarding connection settings (»IP
Address«, »Netmask«, »Gateway« and
»DNS«) must be configured manually.
18 / 119 TR
---------------------------------------------------------------------------------------------------
There are various options when using WLAN:
Automatic connection
Manual connection

Tuning channels

Depending on the type of antenna connected,
you can decide which channels you would like
the television to search for.
DVB-S – Tunes digital channels from the
DVB-C – For setting up digital cable channels
DVB-T – For setting up digital terrestrial
Searching for Analog television channels,
all data regarding connection settings
(»IP Address«, »Netmask«, »Gateway«
and »DNS«) are obtained from modem
automatically.
Depending on the router, you can use the
following options:
– Option "WPS-PBC" (Push Button
Configuration);
– Connecting with a WPS PIN;
– Connecting by entering the network
password.
all data regarding connection settings (»IP
Address«, »Netmask«, »Gateway« and
»DNS«) must be configured manually.
satellite, from page 22.
You have two options for this search:
– the basic installation which presets a
standard selection, e.g. the satellite Astra
19.2° East; you need only start the search;
– the professional installation, which allows
you to make all required settings and set
parameters for your receiver system.
see page 22.
channels see page 23.
see "Setting further channels" section on page
103 .
Note:
See "Setting further channels"" section
7
starting from page 93 for more information
on digital television channel settings.
Television / User Manual