Hayward SP1080-Serie Gebrauchsanweisung Seite 7

INSTALLATION FOR WOODEN PANELS WITH A LINER (SP1084 - SP1085)
1) Cut the panel to about 3 mm larger than the outer edge of the skimmer mouth.
2) Insert the skimmer from the rear into the cutout until the outer flange of the skimmer mouth is fully in contact with the
panel. Fasten the skimmer to the rear of the panel by means of screws for wood that are inserted through the flange.
3) Place the gasket on the front of the skimmer mouth while taking care to align the holes in the gasket with the holes in
the mouth. (A little adhesive will help to hold the gasket in position during installation).
4) Install the liner.
5) Fasten the second gasket and the face plate of the skimmer to the skimmer mouth by means of the 1" screws.
When the pool has a liner, drill the holes in the liner through the face plate, and then insert the screws (one by one).
The screws thus pass through: 1 - the face plate; 2 - the gasket; 3 - the liner; 4 - the panel; 5 - the gasket; 6 - into
the skimmer mouth.
6) When the pool has a liner, cut out the liner around the inside of the face plate.
ADJUSTING THE FLOW RATE:
For maximum flow, pivot the adjustment flap into the open position. To adjust the flow rate, pivot the adjustment flap
to the desired position over the suction intake.
Flow rate adjustment flap
Water level in the pool
2" Plug
7