Werbung
Verfügbare Sprachen
Verfügbare Sprachen
12
ASSEMBLY
To use the wood lathe, you need an adequately sized workbench upon which the lathe can
either be mounted permanently or fastened in place with the help of screw clamps.
12.1
Installation
12.1.1 Lathe bed
The lathe bed is supplied in two parts. The two parts have to be
screwed together if you want to turn long sections of wood.
To do so, use the four provided M8 screws. Use washers on both
sides. To secure the nuts in place, put the spring washers on the
screws before screwing on the M8 nuts.
There are a total of eight holes in the base of the belt array and the
bottom rail of the lathe bed for fastening the lathe onto a
workbench. If you only intend to use the lathe occasionally, it is
advisable to fasten the lathe onto a workbench with screw clamps.
Use at least 3 screw clamps with one as close as possible to the
middle of the lathe bed in order to prevent the lathe bed from
bending when clamping a long piece of wood.
12.1.2 Tailstock
1. First of all, connect the provided hand wheel to the spindle screw.
2. Push the hand wheel onto the shaft and fasten it in place by
tightening the locking screw with the enclosed Allen key.
Place the tailstock on the lathe bed from above.
3. Push the M18 screw through the hole in the base of the tailstock.
Position the guide track plate underneath and screw the locklever
onto the screw.
12.1.3 Tool rest
Fasten the base onto the tool rest using the screw, the guide
track plate and the lock lever. The tool rest is then placed in the
base and fastened in the required position using the locking
screw.
ASSEMBLY
13
WL 1000
Werbung
