Werbung
EN - IMPORTANT INFORMATION
Note:
The motor must be adjusted to the size of the window before full
operation of the roller shutter begins. This is done by running
the shutter all the way up and down without interruption using
the activation control such as a remote control or a control
switch.
If the roller shutter is connected to a connection box or a control
unit with the iohomecontrol
automatically the fi rst time the roller shutter is operated. The
roller shutter runs all the way up and down. Do not interrupt the
adjustment!
If the power has been switched off, pressing the STOP key and
subsequently the UP/DOWN key on the remote control within 30
seconds after reconnection will result in a new adjustment.
Use:
- The roller shutter is intended for operation by persons with the
relative experience and knowledge or persons who have been
given instruction concerning use of the product by a person
responsible for their safety.
- Do not operate the roller shutter if repair or adjustment is
required.
- Before operating ensure that the roller shutter can be oper-
ated without risk of damage to property or injury to people or
animals.
- Disconnect from the mains supply before carrying out any
maintenance or service work and ensure that it cannot be
reconnected unintentionally during this time.
- The product is compatible with products with the
io-homecontrol
- If installed and used correctly, the roller shutter requires a
minimal amount of maintenance only. It may be cleaned with
a soft, damp cloth. In special cases with heavy leaf fall, it may
be necessary to remove leaves and other debris from the side
profi les.
- Children must not be allowed to play with the roller shutter, and
remote controls should be kept out of reach of children.
- Sound pressure level: max 51 dB(A).
- Electrical products must be disposed of in conformity with
national regulations for electronic waste and not with house-
hold waste.
- The packaging can be disposed of with usual household
waste.
Removal:
To remove the roller shutter, use these instructions in reverse
order.
Replace screws in covers to avoid leaks.
logo, the adjustment will take place
®
logo.
®
2
Werbung
