Werbung
Verfügbare Sprachen
Verfügbare Sprachen
4. Technical data
Inlet pressure .....................................max. 10 bar
Adjustable pressure range ...................up to 8 bar
5. Assembly
Appliance should be connected in the direction
of the arrow at the compressor outfl ow. It is also
possible to affi x the appliance to the wall with the
wall mount.
Connect:
Push the nipple on your compressed air hose
into the quick-release coupling, the sleeve will
automati-cally spring forwards.
Disconnect:
Pull back the sleeve and remove the hose.
Warning! As you release the hose coupling,
hold the hose coupling part in your hand to
pre-vent injuries caused by the hose being
thrown backwards.
The compressed air hose is also fi tted with a
quick-lock coupling to which accessories can be
connected as described above.
6. Settings and operation
Close all outputs (Compressor is in operation).
Now pull the control knob (1) on all types. Turn the
knob to the right until the pressure gauge shows
the desired pressure.
After adjusting the pressure, the control knob will
be pushed down again. The thread connectors on
the front and rear sides are for the attachment of
pres-sure gauges. Depending on installation, the
connection opposite must be sealed with a dum-
my plug. The scale classifi cation of the pressure
gauge should lie above the value of the ultimate
pressure. If water builds up in the window, this
should be drained through the drain screw (5, for
R ⅜ " no picture).
7. Cleaning, maintenance and
ordering of spare parts
7.1 Cleaning
•
Keep all safety devices, air vents and the
Anl_Filterdruckminderer_R_1-4_SPK7.indb 9
Anl_Filterdruckminderer_R_1-4_SPK7.indb 9
GB
motor housing free of dirt and dust as far as
possible. Wipe the equipment with a clean
cloth or blow it with compressed air at low
pressure.
•
We recommend that you clean the device
immediately each time you have finished
using it.
•
Clean the equipment regularly with a moist
cloth and some soft soap. Do not use
cleaning agents or solvents; these could at-
tack the plastic parts of the equipment. Ensu-
re that no water can seep into the device. The
ingress of water into an electric tool increases
the risk of an electric shock.
7.2 Maintenance
•
There are no parts inside the equipment
which require additional maintenance.
•
Dirty oil and oil-water mixtures should be han-
ded in to an appropriate collection point.
7.3 Ordering replacement parts:
Please quote the following data when ordering
replacement parts:
•
Type of machine
•
Article number of the machine
•
Identification number of the machine
•
Replacement part number of the part required
For our latest prices and information please go to
www.Einhell-Service.com
8. Disposal and recycling
The equipment is supplied in packaging to pre-
vent it from being damaged in transit. The raw
materials in this packaging can be reused or
recycled. The equipment and its accessories are
made of various types of material, such as metal
and plastic. Never place defective equipment in
your household refuse. The equipment should
be taken to a suitable collection center for proper
disposal. If you do not know the whereabouts of
such a collection point, you should ask in your
local council offi ces.
9. Storage
Store the equipment and accessories in a dark
and dry place at above freezing temperature.
The ideal storage temperature is between 5 and
30 °C. Store the electric tool in its original pa-
ckaging.
- 9 -
24.07.2023 08:44:49
24.07.2023 08:44:49
Werbung
