Werbung
Verfügbare Sprachen
Verfügbare Sprachen
•
If the tool does not function, please clear all debris
and restart again. If malfunction continues malfunc-
tions, please remove the battery immediately and
contact the local service dealers for assistance.
•
The battery pack will become slightly warmer while
charging. This is normal and does not indicate a
problem.
•
Do not place charger in an environment either
extreme hot or cold. It will work best at normal room
temperature.
•
When the battery is fully-charged, unplug your char-
ger from the power supply and remove the battery
pack from the charger.
CAUTION : To prevent damage to the battery
pack, remove the battery pack immediately
from the charger when no LED lights. Return
battery pack and charger to your dealer for
checking or replacing. Do not insert a battery
pack into a damaged charger, it may damage
your battery pack.
•
BATTERY CAPACITY INDICATOR
1.
Battery is equipped with the battery remaining
capacity indicator. (Fig. 7)
2.
Press the lock off button and then tap the trigger;
when the working power is turned on, the remaining
battery power is displayed. After 3 seconds, when the
purple light on the right lights up, it will turn into the
speed light.
3.
Either the indicator light blinks or none indicator
lights, the battery capacity has run out, so the tool
does not operate. In these cases, charge the battery
or replace the dead battery by a fully-charged on.
4.
When two or more indicator lights do not light even
after charging is complete, the battery has reached
the end of its service life.
Indicator Lights (Green Lights)
1
2
3
4
5
6
Fig. 7
Safety Switch
Trigger
INDICATOR LIGHTS
Lighted
Light indication
NOTE:
•
The indicated capacity may be lower than the actual
level during use of the tool.
•
Depending on the conditions of use and the ambient
temperature, the indication may differ slightly from
the actual capacity.
•
CHARGER LED INDICATION
CHARGER
Red light steady on
STANDBY
Red and green light
steady on
WHILE
CHARGING
Red light blinking
Red light steady on
CHARGING
COMPLETE
green light blinking
Red and Green lights
MALFUNCTION
BATTERY
blink alternately
NOTE: The battery will not reach full charge after the first
charge. Allow several cycles (drilling followed by recharg-
ing) for them to become fully charged.
•
SPINDLE LOCK BUTTON
If the wheel or shaft is rotating, do not press the spindle
lock button. The spindle lock is not design to use on
rotating wheel. The spindle lock is designed to assist you
to lock the shaft when installing or replacing the wheel.
Simply press onto the lock button, to use this function. (Fig.
8)
Spindle Lock
Button
30
OFF
Light color
Remaining
Left / Right
capacity
Green light / OFF
≥ 75%
Green light / OFF
≥ 50%
Green light / OFF
≥ 25%
Green light blinking
≤ 10% (Charge the
/ OFF
battery)
Red light blinking
Malfunction
GB
Blinking
Stand by
Charging
Battery too hot
Battery too cold
Full charged
Replace the
battery
Fig. 8
Werbung
