Einhell bavaria BHR 130 Bedienungsanleitung Seite 10

Anleitung BHR 130 SPK 1
GB
Operating Instructions for the
High-Pressure Cleaner
Use
The high-pressure cleaner is designed to clean
vehicles, machines, buildings, facades, etc. in the
private sector.
Items supplied
¼
High-pressure cleaner
¼
High-pressure hose
¼
Spray pistol
¼
Lance point / wide cone
¼
Lance rotating nozzle
¼
Rotating washing brush
Areas of application
Never use the machine in potentially explosive areas
under any circumstances!
The operating temperature must be between +5 and
+ 60 °C.
The machine consists of an assembly with a pump,
which is encased in a shock absorbing housing. For
an optimal working position the machine comes with
a lance and a non-slip pistol grip, whose shape and
configuration comply with the applicable regulations.
Do not cover or modify the lance or the spray nozz-
les in any way.
The high-pressure cleaner is designed to be used
with cold or lukewarm water (max. 60 °C); higher
temperatures can damage the pump.
Do not use water that is dirty, gritty or contains any
chemical products, as these could impair operation
and shorten the life of the machine.
Accessories can be used to carry out work with foam
cleaners, sand spraying and rotary brushes.
The normal lance, the lance with rotating nozzle or
the rotating washing brush can be attached prior to
using the high-pressure cleaner (cf. Fig. 2).
8
23.09.2004 15:46 Uhr Seite 8
Assembly (Fig. 1 and Fig. 2)
Connect the high-pressure hose (4) to the connec-
tion on the high-pressure cleaner (2) and on the
spray pistol (6).
Insert the lance into the spray pistol as shown in Fig.
2 and lock the lance by twisting it.
Connect the water inlet hose (min. Ø 1/2") to the
water connection (3) of the high-pressure cleaner.
A backflow stop must be installed between the water
tap and the high-pressure cleaner! Ask your local
plumber about this.
Connect the mains cable to the socket outlet.
Starting up
Open the water inlet. Press safety pin „a" (Fig. 3) on
the spray pistol and pull back trigger lever „b" (Fig. 3)
in order to bleed the trapped air out of the device.
Turn on the device (Fig. 1, Item 1).
To temporarily turn off, release the trigger lever, at
which point the device goes to standby. As soon as
you press the trigger lever again, the high-pressure
cleaner restarts.
To completely turn off the high-pressure cleaner,
press the ON/OFF switch.
The shape of the water jet can be changed from con-
centrated to flat jet by turning the nozzle (Fig. 4).
Using the lance with rotating nozzle is particularly
effective in cases of very stubborn dirt.
Using cleaning agent
Fill the integrated 2 liter detergent tank (Fig. 1, Item
12) with an appropriate cleaning agent. By pulling
back the nozzle head on the lance, the device will
change to low-pressure operation and the detergent
will be added automatically. The washing brush only
works with low pressure and with automatic deter-
gent mixing.