Verwandte Anleitungen für Pablo LIM360
Inhaltszusammenfassung für Pablo LIM360
- Seite 1 LIM360 ASSEMBLY & INSTALLATION INSTRUCTIONS MONTAGE- & INSTALLATIONSANLEITUNG INSTRUCTIONS D’ASSEMBLAGE ET D’INSTALLATION INSTRUCCIONES DE MONTAJE E INSTALACIÓN ISTRUZIONI PER L’ASSEMBLAGGIO E L’INSTALLAZIONE pg. 1...
- Seite 2 LIM360 LIM360 ASSEMBLY NOTE: CONTACT MANUFACTURER FOR ADDITIONAL PLUG TYPE REQUIREMENTS SLIDE ARM ONTO POST CONNECT LAMP CORD TO POWER SUPPLY TIGHTEN SET SCREW WITH PROVIDED HEX KEY PLUG TYPES: N AMERICA MONTAGE HINWEIS: FÜR ANDERE STECKERARTEN WENDEN SIE SICH BITTE AN DEN HERSTELLER.
- Seite 3 LIM360 LIM360 HI-LO SWITCH PRESS AND HOLD SWITCH FOR 2.5 SECONDS TO TURN OFF. PRESS BRIEFLY TO CYCLE THROUGH THREE STAGES. SCHALTER STARK – SCHWACH ZUM AUSSCHALTEN DEN SCHALTER 2,5 SEKUNDEN GEDRÜCKT HALTEN. UMSCHALTEN ZWISCHEN DEN DREI STUFEN DURCH KURZES DRÜCKEN.
- Seite 4 OUTPUT VOLTAGE: 5VDC + - 5% OUTPUT CURRENT: 1A MAX NOTE: LIM360 WILL CONTINUE TO CHARGE YOUR MOBILE DEVICE EVEN WHEN LAMP IS IN THE “OFF” POSITION. PLEASE REFER TO YOUR MOBILE DEVICE’S USER MANUAL FOR COMPATIBILITY AND CHARGING TIME. PLEASE REFRAIN FROM LEAVING YOUR DEVICE PLUGGED IN FOR LONGER THAN THE RECOMMENDED TIME, OTHERWISE IT MAY RESULT IN OVER CHARGING.
- Seite 5 LIM360 LIM360 BASE INSERT REMOVAL LOOSEN SET SCREW WITH PROVIDED HEX KEY REMOVE ARM FROM BASE. NOTE: REMOVAL OF INSERT IS INTENDED FOR CLEANING AND REPLACEMENT PURPOSES. CONTACT MANUFACTURER TO ORDER REPLACEMENT INSERTS. CARE INSTRUCTIONS: WIPE CLEAN WITH A SOFT DAMP CLOTH. AVOID AMMONIA-BASED CLEANERS.
- Seite 6 LIM360 LIM360 BASE INSERT REMOVAL INSERT PAPERCLIP INTO HOLE ON BOTTOM OF BASE. PUSH UP ON BASE INSERT WITH PAPERCLIP. GRAB EDGE OF INSERT AND LIFT. NOTE: BASE INSERT IS MAGNETICALLY ATTACHED FOR EASY REPLACEMENT. ENTFERNEN DER FUSSAUFLAGE BÜROKLAMMER IN DAS LOCH UNTEN AM FUSS EINFÜHREN.
- Seite 7 INFO@PABLODESIGNS.COM INFO@PABLODESIGNS.EU 888 MARIN STREET SAN FRANCISCO, CA 94124 PABLODESIGNS.COM PABLODESIGNS.EU pg. 12...