Nowsonic Stage Extender Bedienungsanleitung Seite 6

Stage Extender
EN
User manual
DC 5V/2A socket
■
This mains adapter socket is used to connect the supplied power adapter (100 – 240 V; 50/60 Hz 0.4 A) for mains operation.
NOTE: Please note that the internal battery can only be charged by a power source connected to the 5V 1A USB port, and not by the DC 5V/2A
mains adapter socket.
Description of the front panel
The Nowsonic Stage Extender has the following ports and controls on the front panel:
LAN
■
Use this RJ45 port to connect the Stage Extender via a standard
CAT5 cable to a DSL cable modem or directly to the Ethernet port
on a computer in order to connect to the Internet.
ON/OFF switch
■
Use this switch to turn the Nowsonic Stage Extender on or off
during battery or mains operation. When the unit is turned on, the
CPU LED on the top panel flashes: In battery mode, the battery's
charging status will also be displayed by the 20 - 50 - 75 - 100 LEDs.
NOTE: Use a small, sharp pencil or a bent paper clip to push the button in the opening labeled RST on the left-hand side of the housing: If you
press and hold the button for more than 5 seconds, the Stage Extender will be reset to its default settings.
Nowsonic_StageExtender.indb 6
6
www.nowsonic.com
08.03.17 16:20