Saro SVM Bedienungsanleitung Seite 49

BEDIENUNGSANLEITUNG/ USER MANUAL/ MANUEL D'UTILISATION
REPLACING DAMAGED OR BROKEN SEAL WIRES
First remove the Top Teflon layer.
To remove old damaged or
To remove old damaged or
broken seal wires, follow next
broken seal wires, follow next
steps;
steps;
The seal wire is pulled out of
The seal wire is pulled out of
the end block.
the end block.
Before tighten the seal wire,
Before tighten the seal wire,
place back the pressure plate.
place back the pressure plate.
Push it completely to the end.
Push it completely to the end.
Now push the wires into the
Now push the wires into the
end block on the other side of
end block on the other side of
the seal bar.
the seal bar.
Version 12.10 Art. 0894552
Loose the screw of the seal
Loose the screw of the seal
wire that should be changed.
wire that should be changed.
Before replacing the seal wire,
Before replacing the seal wire,
check if both springs are in
check if both springs are in
place, and if the Teflon is good
place, and if the Teflon is good
Now you can tighten the screw
Now you can tighten the screw
to secure the wire. Don't use
to secure the wire. Don't use
to much force for tightening.
to much force for tightening.
Before tighten the seal wires,
Before tighten the seal wires,
first place the pressure plate.
first place the pressure plate.
Before placing the Teflon top
Before placing the Teflon top
layer, first check both sides of
layer, first check both sides of
the seal bar, if all pressure
the seal bar, if all pressure
plates are placed correctly and
plates are placed correctly and
if the spring plates are fully
if the spring plates are fully
pushed in.
pushed in.
.
First pull out the pressure
First pull out the pressure
plate.
plate.
Push the new seal wire into the
Push the new seal wire into the
end block.
end block.
Once both wires are replaced
Once both wires are replaced
and fixed bend both wires to
and fixed bend both wires to
the other end of the seal bar.
the other end of the seal bar.
Tighten the seal wire by
Tighten the seal wire by
turning the pliers clockwise.
turning the pliers clockwise.
Saro
Once the pressure plate is
Once the pressure plate is
removed the seal wire can
removed the seal wire can
pulled from the end block.
pulled from the end block.
Push it till it comes out on the
Push it till it comes out on the
other side.
other side.
In case of a cut-off seal, check
In case of a cut-off seal, check
if the cut-off wire is placed
if the cut-off wire is placed
correctly in to the groove.
correctly in to the groove.
The correct tension is reached if
The correct tension is reached if
both spring plates are pushed to the
both spring plates are pushed to the
end block. Both sides of the seal
end block. On both sides.
bar.
49