Thomashilfen 6836 Montageanleitung Seite 5

Seat minimizer Item code: 6836
The seat minimizer consists of 4 parts: seat wedge, head pillow and two seat
side guide pads. It is started with the fixing of the seat wedge.
Seat wedge:
For positioning of the seat wedge, open the zipper of the back upholstery and
remove the upholstery from the back and seat plate. (fig. 1) Put the seat wedge
with the broader end on the seat, so that this is leaning directly against the back
plate. Now stick the hook and loop strip of the seat wedge onto the seat plate
and secure the seat wedge with the hook and loop. (fig. 2) Afterwards pull the
upholstery over seat and backrest and close the zipper.
Head pillow:
First, guide the shoulder belts through the buckle of the head pillow from below
and fasten the belts on the rear of the back plate. (fig. 3+4) Then the head pil-
low can be positioned in height with the help of the buckles.
Seat side guide pads:
Open the zipper of the seat side guide pads of the Swifty 2 and remove them
from the side plates. Afterwards, pull the seat side guide pads of the seat mi-
nimizer over the side plates and close the zippers. Pay attention that the thick
upholstery point to the inside of the buggy. (fig. 5)
ATTENTION: When folding the Swifty 2 rehab stroller, flip the upholstery of the
seat side guide pads up, so that the upholstery can slide between push handle
and back plate. (fig. 6-8)
TIP: For better positioning of the child, the lateral trunk support can be used in
addition. Simply attach the pads on the back plate and laid the back upholstery
over the pads. (fig. 9+10) Alternatively, the vertical slits in the back upholstery
can be cut open to guide the lateral trunk supports through the slits. (fig. 11)
5