Cleaning And Maintenance - Foster Xtra Fd2-10 Bedienungsanleitung

GB

Cleaning and Maintenance

Important: Before cleaning, the unit should be put into standby and then the power supply
should be turned off at the mains. Please do not plug or unplug the unit with wet hands.
Only when cleaning has been completed and the unit is dry should the cabinet be turned
back on at the mains. Using high pressure water jets or lances is prohibited; the warranty
will not cover problems that result from failure to heed the above warning.
Regular Maintenance:
> As and when required remove all product and shelving (beware of cold and or sharp
components) from the unit. Clean exterior and interior surfaces with mild liquid detergent,
following the directions on the pack at all times. Rinse surfaces with a damp cloth
containing clean water. Never use wire wool, scouring pads/powders or high alkaline
cleaning agents i.e bleaches, acids and chlorines as these may cause damage. Dry the
unit thoroughly before re-using.
> Cleaning the condenser at least once a month (it is located behind the unitcover);
beware of hot and possible sharp components).
On both the cabinet and counter remove the unit cover securing screw(s) positioned
underneath the front of the unitcover. Pull the cover forward and it will release from the
securing pegs to allow access to the condenser coil.
Once the cover is removed please do not leave the unit unattended. Use a soft brush
or vacuum cleaner to remove dirt/dust. If there are any stubborn grease deposits left on
or through the condenser call your supplier to carry out a full service (this is normally
chargeable). Failure to maintain the condenser may invalidate the warranty of the
condensing unit and cause premature failure of the motor/compressor. DO NOT use a
wire brush to clean the condenser. Re-fit any panels removed after cleaning.
> Door gaskets should be inspected on a regular basis and replaced if damaged. To
clean, wipe with a warm damp soapy cloth followed by a clean damp cloth. Finally
thoroughly dry before closing the door.
> Shelves, baskets and their supports should be removed to clean. The shelves are
dishwasher safe; however the supports should be cleaned with warm soapy water then
rinsed and dried.
Before calling your supplier please make sure that:
a) The plug has not come out of the socket and the mains power supply is on i.e. is the
controller illuminated?
b) Check to see if the unit is in standby
c) The fuse has not blown
d) The cabinet is positioned correctly – cold or warm air sources are not affecting the
performance
e) The condenser is not blocked or dirty
f) The products are placed in the unit correctly
g) Defrost is not in progress or required
If the reason for the malfunction cannot be identified, disconnect the electrical supply to the unit
and contact your supplier. When requesting a service call, please quote the model and serial
number which can be found on the silver label located on the inside of the unit (starts E......).
3