Technical Specifications - Innojok Oy INNOSOL Mesa 160 Gebrauchsanleitung

1. Install the fluorescent tubes by following the steps 2,3,5 and 6 indicated in "Replacing the fluorescent tubes".
2. Place the lamp upright on a table using the support. The lamp is designed to not use in a bathroom, sauna or any other
damp place, nor outdoors.
3. If you attach the lamp to a wall, first fasten a screw firmly in the wall and hang the lamp from the hole provided.
4. Connect the plug to a wall socket. The charge must be 220 - 240 V.
5. Use the switch in the electric cord to turn on the lamp. The light levels of the new fluorescent tubes may fluctuate during
the first few hours, but this usually ceases after approximately ten hours of use.
6.
Switch off the power after use.
1. When replacing the tubes, check that the new ones have similar specifications to the originals.
2. Place the lamp on its back on a dry, clean and flat surface. Make sure that the plug is disconnected.
3. Remove the protective shield by gently pressing on its top edge while pulling outwards.
lamp.
4. Firmly grip the base of the fluorescent tube and detach it from the lampholder by pulling it upwards. Detach the upper
end of the tube from its support bracket. Remove the other tube in the same way if necessary.
5. Install the new tube by placing the upper end in the support bracket. Insert tube's contacts into the holes in the
lampholder. Firmly grip the base of the tube and push it into the lampholder until it clicks into place. Install the other tube
in the same way if needed.
6. Once the fluorescent tubes are firmly in place, check that they work before replacing the shade.
-
Please do not discard tubes with normal household refuse. Dispose them appropriately so as not to endanger people or
the environment.
Keep the lamp clean and dust free. Always disconnect and allow tubes to cool down before cleaning. Use a damp cloth to
clean its outer surfaces as well as the fluorescent tubes and inner surfaces. Do not use any solvents or detergents which may
harm the surfaces. Do not let any water leak into the lamp.
IMPORTANT
•
Do not let children play with the lamp
•
If the electric cord is damaged, it must be replaced by an authorised electrician
• weight 4,9 kg
• length 65 cm, width 40,5 cm, depth 11 cm
• fluorescent tubes 2 x 80 W, 4 000 K
• surface luminosity 11 000 cd/m
• electronic ballast
• charge 220 – 240 V/50 Hz
• 3,0 m electric cord with earthed plug
USE OF THE LAMP
REPLACING THE FLUORESCENT TUBES
MAINTENANCE OF THE LAMP

TECHNICAL SPECIFICATIONS

2 2
, max. 18 000 cd/m
• opaque glare- and UV-protective shade
• powder painted body of zinc plated steel
• adjustable leg
• wall mount option
• therapy distance 105 cm (2 500 lx)
• FI approved by the Electric Inspectorate of Finland
(SGS Fimko), certified DNV0434 Class 2A
English 3
Remove the shade from the