SINGCALL APE6600 Bedienungsanleitung Seite 2

Manual for Mobile Receiver（APE6600）
●Number Registering
If you can't register numbers, it means that the watch is locked. You can see the last page to
unlock it.
1) Standby mode, press the key [FUN] for 2 seconds till F1 appears on the LED screen.
2) Keep pressing the key FUN till 001 appears.
3) Press the key FUN to move the place of the flashing number and press the key ENT to change
the number.
4) Press the call button to be registered. When the mobile host beeps with flashing number, the
registration is finished.
5) To register all the call buttons needed, please repeat step (3) ~ (4) after the first one finished.
6) After registration, keep pressing the key FUN till F1 appears.
7) Keep pressing the key ENT till back to standby mode.
※Special notes
1) Ten sets of scroll numbers can be reserved on the host. For example, when "1 002" appears on
the screen, it means that there was a number called before 002 and 002 is the second number
calls.
2) For the multi-button pagers, the mantissa on the screen means different call functions, 6
means service, 8 means bill. For example, "001-6" means that 001 is paging for service. "001-8"
means that 001 is paging for bill. When the key CANCEL of the pager is pressed, the calling
number on the LED screen disappears and it means the service is done.
●Prompt mode setting
1) Standby mode, press the key FUN for 2 seconds till F1 appears.
2) Press the key ENT repeatedly till F2 appears.
3) Keep pressing the key FUN till a number between 001~005 appears. Press the key ENT to
choose the number wanted (number 000 means beep prompt, while number 001~005 means
vibration prompt. The vibration time can be changed from 1 second to 5 seconds as required.)
4) Keep pressing the key FUN till F2 appears.
5) Keep pressing the key ENT till back to standby mode. The setting is done.
●Time display setting
1) Standby mode, press the key FUN 2 seconds till F1 appears.
2) Press the key ENT repeatedly till F3 appears.
3) Keep pressing the key FUN, a number between 001~099 appears. Press the key ENT to choose
the displaying time you wanted. The number 001 to 099 is the time of display, from 1 second to
99 seconds accordingly. The number 000 means unlimited time.
4) Keep pressing key FUN till F3 appears.
5) Keep pressing key ENT till back to standby mode, the display time setting is done.
●Delete registered numbers
1) Standby mode, press the key FUN for 2 seconds till F1 appears.
2) Press the key ENT repeatedly till F4 appears on the LED screen.
2