Herunterladen Diese Seite drucken

INSTA light 1065 R A single 920mm Bedienungsanleitung Seite 3

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

instalight 1065 R A single 920mm
Safety instructions
Electrical devices may only be mounted
and connected by electrically skilled
persons.
Serious injuries, fire or property damage
possible. Please read and follow manual fully.
Only the manufacturer may exchange the
connecting cable. In case of damaged
connection cable, send the luminaire to the
central customer service office of the
manufacturer.
Do not operate the luminaire on a conventional
dimmer. Use DALI control unit for dimming
(variant 'DA' only).
If the protective glass is damaged, replace the
entire luminaire.
Do not damage the powder coating. A damaged
powder coating can lead to corrosion.
Chemicals may endanger the corrosion
protection. Avoid contact with aggressive media
(e.g. acids).
These instructions are an integral part of the
product, and must remain with the end customer.
Device components
Figure 1
(1) Luminaire housing
(2) Protective glass (Light output)
(3) Clamping disc
(4) Connecting cable
(5) Connecting plug (variant 'S' only)
(5) Free cable ends (variant 'L' only)
(6) Retainer clamp
Function
Intended use
Compact LED Facade spotlight. To accentuate
architectural elements in indoor and outdoor areas.
Suitable for wall, ceiling and floor mounting.
Variant 'DA': Dimmable via integrated DALI interface.
Light technology
24 white LED light sources.
Beam characteristics dependant on choosen optics:
Asymmetrical, axially symmetrical or oval.
Light colour, beam angle and -characteristics see
device label.
Lamps / Maintenance
High-performance LED lamps. Lifespan
(L80/B10): 60,000 h.
The lamp may only be replaced by the manufacturer.
In case of damaged connection cable, send the
luminaire to the central customer service office of the
manufacturer.
Cleaning
Before cleaning, switch the luminaire off and let it
cool down. Clean the luminaire housing with a
moistened soft towel.
The protective glass can be cleaned using the same
cleaning agents approved for use on glass-ceramic
cooktops.
Information for electrically skilled
persons
Fitting and electrical connection
DANGER!
Electrical shock when live parts are
touched.
Electrical shocks can be fatal.
Before connecting the luminaires,
disconnect the supply line.
Installing the luminaire
o
To install the luminaire, first loosen the side
clamping discs (3) using a TORX 30 pin wrench
and remove the retainer clamp (6) from the
luminaire housing (1).
o
Fit boreholes (Figure 2).
i Use both of the external holes in the retainer
clamp at least for the installation.
o
Fasten the retainer clamps (6) to the installation
substrate using two suitable screws.
o
Insert the luminaire housing (1) into the retainer
clamp (6).
o
Push on the clamping discs (3) on both sides of
the retainer clamp and hand-tighten the screw
using a TORX 30 pin wrench.
Figure 2: Drilling dimensions
Figure 3: Installing the luminaire
Electrical connection – General Instructions
Observe the maximum number of luminaires (n)
per circuit:
Circuit breaker
max. no. of luminaires
B10
14
C10
23
B16
23
C16
37
Observe connection assignment:
Connection
Contact ('S')
External cond.
L
Neutral cond.
N
/
Earth cond.
DALI*
D1
DALI*
D2
*) variant 'DA' only
instalight 1065 R A single 920mm
Art. No. il 1065 A...00/DA
Operating instructions
Insta Elektro GmbH
Postfach 1830
58468 Lüdenscheid
Telefon +49 2351 936-0
www.insta.de
info@insta.de
Connecting the luminaire (variant 'S')
WARNING!
Destruction of the plug contacts when
connecting or disconnecting the plug
under load.
Before connecting or disconnecting the
plug, disconnect the supply line.
The luminaire variant 'S' is fitted with the plug-in
system "Wieland gesis
For connection use the cables and connectors listed
under "Accessories".
i Please observe the technical documentation of
the "Wieland gesis
o
Wire the luminaires according to connection
diagram:
– Single connection with socket RST (7)
– Chain-linking with Y-Connector RST (8)
– Wiring with extension cable RST (9)
Wire col. ('L')
Brown
Blue
Green-yellow
Black
Grey
0000000034
22.07.2015
®
RST 20".
®
" plug-in system.

Werbung

loading