With the tap clamp pressed, pull the hose out the bottom of the tap,
by about 2 cm. The hose should not be broken or twisted!
Let go of the hose clamp and cut off the hose directly below the tap
using a pair of scissors (see image 2).
Finally, close the doors and liquid can be withdrawn by pressing the
tap clamp (see image 3).
1
2
38
3
11 Switching on the LED door lighting
(optional)
The light switch for the LED door lighting is located in the bottom
frame of the door on the left-hand side.
12 Changing the door film
In order to provide the door with a picture or advertising slogan,
loosen the three screws on the top door frame and remove the frame.
The first time a change is made, pull the black protective film upwards
out of the door. Then push in the new translucent (transparent) film
from above. Alternatively the perspex panel, which lies be-neath the
protective foil, can also be covered with an adhesive. Then put the
frame back in position and fasten the three screws.
39