Werbung
Verfügbare Sprachen
Verfügbare Sprachen
2.
Connect the angle rod „B" to the sponge head „C" and lock it in the eyelet provided.
Attention: after insertion, the sponge head can no longer be removed.
3.
Then push the spray head and extractor unit „E" into the end of the angle bar „B"
for fastening and lock it there.
Operating the SEECODE window cleaner 3-in-1
The telescopic pole can be opened and closed by screwing on the white connector to
lengthen or shorten the pole.
The spray head and squeegee unit can also be used without the telescopic pole.
The spray head and squeegee unit can be set at a 45 degree angle to the left and right
to better reach hard-to-reach places when needed. To do this, press the black button on
the angle bar.
Fill the bottle with water and, if necessary, some window cleaning agent.
Spray the entire surface of the window.
Then clean the window with the sponge unit.
Simply pull the water off with the high-quality pull-off lip towards the bottom. The collec-
ted water is caught in the container of the squeegee. The water can be easily poured out
through the stopper on the side.
When pulling off for the first time, please move the squeegee slowly in vertical paths
until the squeegee lip is completely wetted.
Hold the extractor straight so that no water can spill over to the side.
The waste water tank should be emptied after each cleaning.
The squeegee effect is impaired if the squeegee lip is contaminated. Please always
rinse before use.
Care and maintenance
Care instructions for the wiper pads: Material: 90% polyurethane and 10% polyester.
Hand wash to a maximum of 40° or machine wash to a maximum of 60°.
Do not tumble dry / Do not bleach.
Clean with a soft, slightly damp cloth if necessary. Do not use abrasive cleaning agents
or harsh chemicals. Do not use metallic cleaning objects.
Guarantee/Warranty
8
Werbung
