Numark MP302 Kurzanleitung Seite 7

BEAT MATCHING USING PITCH BEND
If you find the BPM's (Beats Per Minute or Tempos) are the same, however, the drum beats are not matched you will need to
temporarily change the pitch. The illustration below shows how to match the beat of PLAYER 2 to the beat of the music being
played on PLAYER 1. (This procedure can be done on either PLAYER).
After matching the BPM's adjust the pitch temporarily as follows:
When PLAYER 2 is ahead, rotate the jog wheel counter clockwise.
The pitch changes automatically while the jog wheel is rotated. The faster you rotate the wheel the more you change.
Releasing the wheel results in a return to the original pitch (so the BPM's are once again the same).
EXAMPLE OF MIXING USING BOTH PLAYERS OF YOUR CD PLAYER
While playing a disc on PLAYER 1, load a disc into PLAYER 2 and select your next track, match its pitch to the track playing on
PLAYER1 and when you are ready use the crossfader on your mixer to fade from PLAYER 1 to PLAYER 2.
Load a disc in PLAYER 1 and
select the track and press PLAY.
Load a disc in PLAYER 2 and
select the track then play.
Set and edit a start cue point on
PLAYER 2
Check your new cue point
Do a MIX!
P LAYER 1
Loa d a dis c a nd pre s s the
OPEN/CLOS E button.
P LAYER 2
Loa d a dis c a nd pre s s the
OPEN/CLOSE button.
P LAYER 2
Pre s s the Pa us e button of P LAYER 2.
P LAYER 2
Lis te n with the monitor a nd
pre s s the pla y button.
P LAYER 2
With a ma tching downbe a t from
P la ye r 1 pres s the pla y button.
When PLAYER 2 is behind, rotate the jog wheel clockwise.
P LAYER 1
Se le ct the tra ck to be pla yed.
P LAYER 2
Se le ct the tra ck to be pla yed.
P LAYER 2
Ra pidly s e a rch for a cue point us ing
the oute r whe e l
P LAYER 2
P re s s the cue button the n pla y to be
s ure of the s e t cue point.
P LAYER 2
If you a re be a t mixing, turn on your
P itch a djus t a nd follow the directions
for beat matching.
7
P LAYER 1
P re s s the PLAY button
P LAYER 2
P re s s the PLAY button
P LAYER 2
S lowly s e t the right cue point
us ing the inne r whe e l
P LAYER 2
Re s e t the pla ye r to the Cue point
by pres s ing Cue
MIXER
When you a re ha ppy with your mix
move the cros s fa de r a ccordingly.