Werbung
Verfügbare Sprachen
Verfügbare Sprachen
COMPUTER MANUAL
DISPLAYS
[TIME] Display: Shows actually time of exercising in minutes
and seconds.
[SPEED] Display: Shows actually speed in km/h during exer-
cise mode. Shows programs P01-P06 in stop mode.
[DISTANCE] Display: Shows actually distance in Km.
[CALORIES] Display: Shows actually calories in kcal.
KEYS:
[P]
Key:
exercising speed programs P01-P6
[Start] Key: Press this key to start exercise pro-
gram. The runing surface starts delayed by 3
seconds.
[Stop/Pause] Key: Press this key during exer-
cise to interrupt the program (motor stops run-
ning). Within 5 min. you can press [Start] key to
continue this exercise program or press
[Stop/Pause] key again to finish this program.
Prevalues can set to zero by pressing the [Stop/
Pause] key.
[+] Key: Press this key to increase settings or
motor speed.
[-] Key: Press this key to decrease settings or
motor speed.
[M] Key: Press this key to select the time dis-
tance or calories in the manual program.
press
this
key
to
START UP
The walkingpad can only controlled with the supplied remote
control. The remote control requires a button cell type CR2032.
Insert the battery into the remote control, observing the polar-
ity. Guide the wristband through the two openings on the back
of the remote control to carry the remote control on your wrist
and to operate it. The range is approx.1.5m. If the remote con-
trol does not respond, first change the battery.
PROGRAMS
Manual Program
select
1. Put in the AC cable (57) in wall power 230V~50Hz and put on
the power switch (46) and it will show normal manual mode.
2. Stand your feet on both side rails.
3. Press [ ] key to start with exercising. After a 3 sec. count down,
the motor begin to run slowly and you can step on the running belt
and follow the speed.
4. Adjust the speed with [+] and [-] keys into desired speed.
Time- Program:
On the normal manual mode, press [M] key, to enter time pro-
gram. The time display will flash and the initial value is 30:00.
Press [+] or [-] keys to set value. The range is: 5:00-99:00. Press
[ ] key to start the program. If set a value the display counts up till
zero and then stops running motor.
Distance- Program:
On the normal manual mode, press [M] key, to enter distance
program. The distance display will flash and the initial value is
1,00KM. Press [+] or [-] keys to set value. The range is: 0,5-65:0
KM. Press [ ] key to start the program. If set a value the display
counts up till zero and then stops running motor.
Calories- Program:
On the normal manual mode, press [M] key, to enter calories pro-
gram. The calories display will flash and the initial value is 50kcal.
Press [+] or [-] key to set value. The range is: 10-995kcal. Press [
] key to start the program. If set a value the display counts up till
zero and then stops running motor.
RANGE OF ALL FUNCTIONS
TIME (Min:Sec)
KM/H
KM
CALORIES (Kcal) 0
14
Initial
Setting
Initial
Value
Range
0:00
30:00
5:00-99:00
0.0
N/A
N/A
0.00
1.00
0.5-65.0
50
10-995
GB
Display
Range
0:00-99:59
0.8-5.0
0.00-99.99
0-999
Werbung
