HEADRUSH CORE Schnellstartanleitung Seite 6

Basic Operation
This chapter describes some of HeadRush Core's basic functions. You can visit
the complete user guide for even more information.
Main Screen
Tap to view the Menu
page and access more
features and settings.
Double tap to view
the Input Settings
page.
Turn the encoder to
move through
selectable items
onscreen or to
adjust parameters.
Press the encoder
as an Enter
command.
Important: The sequence of blocks in your signal chain is not necessarily reflected in the footswitches. You can
freely assign blocks to available footswitches without changing your signal chain at all—and vice versa.
To assign a block (amp, cab, impulse response, or effect) to an empty slot, tap it (+) and then use the list that
appears.
To show a block's detailed settings screen, double-tap it.
To rearrange the blocks in your signal chain, tap and drag a block to another
slot or between two other blocks (the ones after that position will shift one slot
further down the signal chain).
To activate or deactivate a block, press the footswitch assigned to it, or tap
the block and then tap the On/Off button that appears in the top right corner of
the screen.
To remove a block, tap and hold the block and then drag it to the bottom bar.
To load another rig (preset):
•
Tap the  or  next to the name of the current rig on the screen.
•
Tap the name of the rig on the screen and then turn the encoder.
•
Press a footswitch assigned to a preset when HeadRush Core is in Rig View.
•
Press a footswitch assigned to Prev Rig or Next Rig when HeadRush Core is in
Hybrid View.
To view other options, tap the Menu icon in the upper-right corner, and then tap an option.
6
Tap and drag this bar downwards to
view the Rig List page. Double tap
to rename the rig.
These five blocks show the current function of the 5 footswitches. Hold
Footswitch 2 (VIEW) to change the footswitch mode.
headrushfx.com
Tap this icon to view the Hardware Assign
page.
to download
Tap to save a rig.
Tap to change the
signal chain type.
(guitar, vocal,
guitar/vocal, etc.)
Tap to enable/disable
reverb and delay tails
when changing the rig.
Double tap to view the
Output Settings page.
Double tap an effect,
amp, or cab to view its
Detailed Settings page.