Herunterladen Diese Seite drucken

Kivi 40F740NB Benutzerhandbuch Seite 10

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 18
WHEN SOMETHING GOES WRONG
EN
In addition to hardware-related malfunctions, if there are any non-standard operations,
power me off for 30 seconds.
Unstable or
1. I'm on the
missing
antenna, but I
broadcast /
cannot nd
cable TV signal
channels, and I
broadcast channels
with image
distortion or audio
interruptions.
2. I'm cable, but I
don't nd
channels, and I
broadcast
channels with
image distortion
or audio
interruptions.
Sound is
1. Connecting
not played on
speakers via
external
Bluetooth
speakers
2. Connect speakers
via HDMI
3. Connect
speakers via AUX
(3.5 mm
headphone jack)
4. Connecting
speakers via optics
9
1. For stable reception of DVB-T2 (digital) and ATV (analog) signals, use an external
antenna with an ampli er (gain 30 dB and more).
Additional power to the antenna input is already transmitted and cannot be
supplied via my USB ports.
Point your antenna toward the nearest TV tower.
If you are using a room antenna, raise it higher, rotate it around your own axle, and
move it around the room.
Make sure that you have selected an antenna in the settings ->Channel -> channel
setup mode menu.
Con gure the channels manually.
For a stable image and sound, the indicators shall be from 50% or higher.
Check the integrity of the cable.
2. If you are using cable TV (DVB-C) or a common house antenna, I recommend
connecting without a splitter. If possible, connect me to another antenna cable.
Make sure that you have selected an antenna in the Settings -> Channel -> Channel
setup mode menu.
Con gure the channels manually.
Check the integrity of the cable.
Use a signal ampli er.
1. Connect Bluetooth speakers via the Settings menu – Remote controls and
accessories
- Add a device.
2. Connect the speakers to me via the HDMI (ARC) Jack.
In the Settings menu -> Sound -> Speakers — select "External audio system". In the
Settings menu –> Device Settings -> Inputs - > HDMI EDID version
- set the value to "EDID 1.4".
In Settings menu -> Device Settings - > Sound -> digital output - select Auto, Skip,
PCM, etc.
3. Make sure that the audio cable is inserted all the way into the 3.5 jack.
4. Attach the speakers to the OPTICAL connector.
In the Settings menu - > Device Settings - > Sound -> Digital output-> select Auto,
Skip, PCM, etc.
Use the VOL button on the remote control to turn down the sound volume until it is
completely turned o . Use the remote control from the speakers to increase the
sound to the desired level.
kivismart.com

Werbung

loading