Kruger & Matz KM0232-T4 Bedienungsanleitung Seite 18

BASIC OPERATION
1. Connect the device to power supply
socket.
2. Connect the antenna cable into
the appropriate RF input.
Switch the TV on and off
1. When the TV is connected to power supply, it will be turned on directly or
be in standby mode (power LED is on). If the TV is in standby mode, press
the Power button to turn it on.
2. To put the TV set into standby mode, press the Power button on the TV set
or remote control. The TV set remains on, but with low energy consumption.
To switch off the TV set, unplug it from power supply.
Note: For some models, press the Power button to switch off the TV set.
INITIAL SETUP
The first time you switch the TV set on, the Welcome screen appears, which
guides you through the initial setup process. Follow the on-screen instructions
to finish the initial setup process such as selecting the language, scanning
channels and more. During each step, either make a choice or skip the step. If
you skip a step, you can perform the setup later from the settings menu.
18
Owner's manual