Werbung
Verfügbare Sprachen
Verfügbare Sprachen
SKU 11520 TORQUE WRENCH SET
USER INSTRUCTIONS
1.
Hold the key so that the directional arrow and the scale are visible.
2.
Unlock the knurled knob by loosening the rear locking ring in a clockwise direction.
3.
Turn the knurled knob clockwise until it is near the desired scale value.
4.
Then proceed as follows:
•
for the values l 0 -18 -42 Nm
•
for the values 55 -65 -75 Nm
Value to be set
100 Kg x cm (10 Nm)
160:180 Kg x cm (16:18 Nm)
420 Kg x cm (42 Nm)
550 Kg x cm (55 Nm)
650 Kg x cm (65 Nm)
750 Kg x cm (75 Nm)
* For torque values other than those shown in the table, it is sufficient to refer to a known value
and increase or reduce the torque by turning the knob whereas at each mark correspond
5.
Lock the torque adjustment by tightening the ring nut.
Upon reaching the pre-set torque, the user will feel a click and a lightening of the effort.
•
To avoid damage to the tool, never bring the adjustment below 1O newton meter.
•
In order to avoid any damage to your tool, stop bringing pressure on the wrench after you have reached the desired
tightening torque.
•
Always bring the wrench back to the minimum values after use, in order not to damage the tightening precision.
•
In case you have not used the wrench for a long period of time, make a few clicks with the torque at the scale lowest
value, so that the wrench can lubricate.
•
The fork face with the number on it must be on the same level as the direction arrow and as the scale, as shown on the
drawing.
Approximative value to set
180 kg x cm (18 Nm)
420 kg x cm (42 Nm)
550 kg x cm (55 Nm)
650 kg x cm (65 Nm)
Company with certified
quality system
SGS ISO 9001/2015
slowly turn the knurled knob to coincide
the notch "10" - "18" - "42" of the knob with the vertical of the scale.
slowly turn the knurled knob to coincide
the notch "O" of the knob with the vertical of the scale.
Vertical scale value
10 Kg x cm (1 Nm).
WARNINGS
Conventional torque wrench
Conventional torque wrench
Conventional torque wrench
Conventional torque wrench
TECNOGAS srl
T. +39 049 8625910
Viale L. Da Zara, 10
F. +39 049 8625911
35020 Albignasego
info@tecnogas.net
Padova - Italy
www.tecnogas.net
Knob scale value
10
16:18
16:18*
42
55
65
75
1/4
About the tightening torque values to set,
3/8
please refer only to the air-conditioner
1/2
5/8
10
42
0
0
0
WARNING
installation manual.
EN
Werbung
