M7 DW-404 Bedienungsanleitung Seite 11

WARNING
If any part is broken or missing, DO NOT
attempt to attach the battery or operate
the tool until the broken or missing part is
replaced. Failure to do so could result in
possible serious injury.
WARNING
Do not attempt to modify this tool or create
accessories not recommended for use with
this tool. Any such alteration or modification
is misuse and could result in a hazardous
condition leading to possible serious injury.
WARNING
Your tool should never be connected to the
battery when you are assembling parts,
making adjustments, installing or removing
blades, cleaning, or when it is not in use.
Disconnecting the tool will prevent accidental
starting, which could cause serious personal
injury.
TO ATTACH BATTERY
PACK (FIG. 1)
FIG. 1
Release Button
Detach
1. Make sure that the sander is switched
off.
2. Align the raised rib on the battery pack with
the grooves on the bottom of the Impact
Wrench, and then slide the battery pack
onto the tool.
ASSEMBLY
ASSEMBLY
Attach
UNPACKING
1. Carefully remove the tool and any
accessories from the carton. Make sure
that all items listed in the packing list are
included.
2. Inspect the tool carefully to make sure that
no breakage or damage occurred during
shipping.
3. Do not discard the packing material
until you have carefully inspected and
satisfactorily operated the tool.
NOTICE: Make sure that the latch on the
battery pack snaps into place and the battery
pack is secured to the cordless tool before
operation.
TO DETACH BATTERY
PACK (FIG. 1)
1. Make sure that the cordless tool is
switched off.
2. Depress the battery-release buttons
located on the front of the battery pack to
release the battery pack.
3. Pull the battery pack out and remove it
from the cordless tool.
11