Balluff BIS C-830-4-011-A Kurzanleitung Seite 5

BIS C-830-4-011-A
Mobile RFID devices - LF plug-in module
Using the plug-in module
Plug-in module
The module can be used on the top module slot of the
basic device.
Attaching and removing the plug-in module
CAUTION
Risk of injury from crushing or squeezing
There is a risk of injury from crushing or squeezing during
sliding when attaching and removing the module. The
scanner glass may also become soiled.
► Do not reach into the area of the plug-slide
mechanism when attaching and removing the
module.
► Do not touch the scanner glass with fingers.
The plug-in module can be attached and removed by
sliding it to the side (see picture).
www.balluff.com
Fitting and removing the M18 adapter
An adapter ring (included in the scope of delivery) is
required for a stable connection of the plug-in module and
read/write head (BIS C-325/05-S4) in M18 design.
Fitting the adapter
1. Place the adapter ring on the mounting opening for
read/write heads from the inside.
Adapter ring
Mounting opening
2. Press the adapter ring against the mounting opening
from the inside until the adapter ring engages.
Removing the adapter
1. Push the adapter ring from the outside to the inside.
2. Remove the adapter ring.
Fitting the read/write heads
For a stable connection of the plug-in module and
read/write head, mounting with 2 hex nuts is
recommended.
To avoid damage to the housing, mount the
read/write heads without tools.
1. For BIS C-325/05-S4 only: Insert adapter ring into
mounting opening from the inside (see section Fitting
the adapter, not shown).
2. Position the inner hex nut from the inside at the
mounting opening for the read/write head.
Inner hex nut
Read/write head
3. Screw the read/write head into the hex nut from the
outside.
4. Plug the read/write head into the M12 socket. Pay
attention to the A-coding of plug and socket.
5. Screw on the inner hex nut until it touches the
mounting opening, then tighten it by half a turn
(≤ 2 Nm).
6. Screw on the outer hex nut from the outside and
tighten it against the inner hex nut (≤ 2 Nm).
Outer hex nut
english 2