Wilfa DRY CONNECTED DH2W-20C Anleitung Seite 15

STORAGE
If you are not using the unit for an extended period (more than a 3 weeks), clean and
dry it completely.
1. Switch off the unit and unplug it.
2. Empty the water tank and let it dry. If it is connected to the drain hose, check that
it is empty, disconnect it and make sure it is dry.
3. Remove the filter and clean with warm water. Let it dry before reinstalling it.
4. The unit must be stored in upright position.
5. Store it in a ventilated and dry space indoors free of any corrosive gases.
The evaporator inside the unit must be completely dry before storing. This is to avoid
component damage and moulds. Unplug the unit and place it in a dry and open area
for days to dry it out. Another way to dry it is to set the humidity point more than 5%
higher than the ambient humidity to force the fan to dry the evaporator for a couple of
hours.
TROUBLESHOOTING
Functioning temperature 5°C -35°C.
When the temperature is lower or higher than the functioning temperature, the unit
stops.
When the temperature is between 5°C and 16°C the compressor automatically
defrosts at intervals. During defrosting the compressor stops and the fan keeps
running.
Problem
The unit does not
work
Bad function
No air intake
DEHUMIDIFIER · DH2W-20C
Possible reasons
No power supply
Water tank full indicator
is on
Room temperature is
lower than 5°C or higher
than 35°C.
Filter clogged
intake duct or discharge
duct obstructed
Filter clogged
15
Solutions
Connect to a functioning outlet
and switch the unit on
Empty the water tank and place it
correctly back into the unit.
Self-protection designed to
protect the unit is activated.
Can not work under these
temperatures.
Clean the fi ter
Remove the obstruction from the
discharge duct or intake duct.
Clean the fi ter
EN