Herunterladen Diese Seite drucken

Skytec SP Serie Bedienungsanleitung Seite 13

Vorschau ausblenden Andere Handbücher für SP Serie:

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

TROUBLESHOOTING
One certain method of determining if a speaker is faulty is to substitute a speaker that is known to work
correctly for the suspected problem speaker. If the "normally correct speaker" is experiencing the same
difficulties or problems as the suspected problem speaker, use the information below to isolate the problem.
No output
Possible cause
Speaker cables
Intermittent
Possible cause
Poor connections
Constant noise, buzzing and/or humming
Possible cause
Faulty electronic
device in the signal devices, or line-level wiring. Check and correct system grounding as required. Chain
check for noisy sources or electronic components. Check wiring for shielding.
Type
Power
Peak power
Woofer
Horn
Hi Compres Titan
Freq range
55Hz-18kHz
SPL
Voltage
220-240Vac/50Hz
Dims
330x280x530mm
Weight
Supplied
Electric products must not be put into household waste. Please bring them to a recycling centre. Ask your local
authorities or your dealer about the way to proceed.
The specifications are typical. The actual values can slightly change from one unit to the other. Specifications can be
changed without prior notice.
WARRANTY CONDITIONS
The date the product leaves the importer is considered to be the date the warranty begins. The law obliges the retailer to
offer a two year quarantee to the enduser.
Only companies approved by Tronios are allowed to work on the equipment.
During warranty period (defective) equipment must be returned to the dealer by pre-paid mail in the original box.
Potentiometers have a limited lifetime and are not covered by the manufacturer for more than normal use.
For all service enquiries,refer to your local distributor,as he is best able to help you.
Action
Reseat all connectors
Inspect cable for damage
Inspect wire or connector for stray strand that may short
Action
While it is possible for a faulty speaker to exhibit intermittent output, it's more likely
that an output cable/connector is the problem.
Reseat all connectors
Action
Any constant noise originates in the amplifier, mixer, signal processing, source
170.326
200
400
10"
Hi Compres Titan
120dB
220-240Vac/50Hz
430x395x630mm
14kg
Per Piece
170.328
300
600
12"
Hi Compres Titan
50Hz-18kHz
122dB
220-240Vac/50Hz
17kg
Per Piece
170.330
400
800
15"
40Hz-20kHz
126dB
445x460x735mm
18.3kg
Per Piece

Werbung

loading