Werbung
Verfügbare Sprachen
Verfügbare Sprachen
1. Turn the head of the device slightly to the right
and remove the head.
2. Hold the miniature blade under
running water so that the stream
of water runs over the razor
blade.
3. Leave the miniature blade to dry completely
before you reattach it to the device.
Cleaning the comb attachment
Blow on the comb attachment after the application
in order to clean it of hair. Fine hairs can also be
removed with your fingers.
To clean the comb attachment particularly thorough-
ly, you can rinse it under running water.
Proceed as follows:
1. Pull the comb attachment off the device.
2. Hold the comb attachment under running water.
3. Leave the comb attachment to dry completely
before you reattach it to the device.
– Ensure that no water enters the device. If this
should happen, do not use the device again until
it has fully dried out.
– Protect the device from impacts, moisture, dust,
chemicals, marked temperature fluctuations and
nearby sources of heat (ovens, heaters).
– Clean the device after use with a soft, slightly damp
cloth. If it is very dirty, you can also moisten the
cloth with a mild soapy solution. Do not use any
abrasive cleaning products.
9. Disposal
For environmental reasons, do not dispose
of the device in the household waste at the
end of its service life. Dispose of the device
at a suitable local collection or recycling point in
your country. Dispose of the device in accordance
with EC Directive – WEEE (Waste Electrical and
Electronic Equipment). If you have any questions,
please contact the local authorities responsible for
waste disposal.
Batteries must not be disposed of in the household
waste. They may contain poisonous heavy metals
and are subject to special refuse treatment.
20
Werbung
