fontastic Cero Bedienungsanleitung Seite 2

GB
User manual
Thank you for purchasing this Fontastic
„Cero" with active noise cancellation. Please read the
user manual carefully and follow the safety instructions.
Package contents
• 2 x Cero wireless headset
• Storage and charging case
• USB Type-C charging cable
®
• 3 pairs of ear tips
• User manual
Overview:
1. Multifunction sensor
2. LED/microphone
3. Speaker
4. Silicone earpiece
5. Headset charging contacts
6. Microphone
7. LED charging case
8. USB-C fast charging port
Getting Started
Charging the headsets
Insert the headsets into the charging case slots. Close
the charging case. By closing the charging case, the
headsets get contact and are automatically charged in
the case.
Charging the case
Connect the charging cable that came with the case
to the Type-C charging input of the case and a travel
®
charger or USB port of a computer to charge the built-in
battery. The charging status indicator flashes red during
charging, changes to white when fully charged and goes
out after a few seconds.
Switching On/Off
Automatic:
Take both headset units out of the charging case, they
turn on automatically. Put the headsets into the charging
case and close it, the headsets turn off automatically.
Manual:
Tap and hold the multifunction sensor for 3 seconds,
the headset will turn on.
1
TWS Headset
®
2 4
1
3
5
6
7
8
Tap and hold the multifunction sensor for 6 seconds, the
headset will turn off.
Note: The headset units can also be used
individually.
Note: Both headsets turn on and off automatically
when removed from the case or inserted.
Pairing
The Cero headset must be paired with a Bluetooth
enabled device to be used.
1. By removing both headset units from the charging
case, they will automatically turn on, sync with each
other, and enter pairing mode to connect to a
Bluetooth source.
®
2. Search for „Cero" on your Bluetooth
device and select it from the list of found devices to
pair the headset with the Bluetooth device.
Note: When the headset is placed in the charging
case, the connection is interrupted. As soon as
both headsets are removed, they will automatically
reconnect. If the headset units do not connect auto-
matically or an existing connection is disconnected,
switch both headsets off and on again either by
inserting and removing them from the charging
case, or manually.
Note: If the headset does not find a Bluetooth
bled device, it switches off after approx. 2 minutes.
Fitting the headset
If necessary, replace the fitted
earpieces with ones that are the
right size for you. Choosing the right
earpieces will give you better
sound quality and noise cancellation.
Carefully insert the headsets into the ears and adjust the
headsets so that they fit comfortably in the ear.
Music Control
All control commands are executed with the
multifunction sensor.
Play/Pause: Double-tap the multifunction sensor on
either headset.
GB
®
enabled
®
-ena-
®
2