Werbung
Instruction-manual:
Please note the following points before installation:
- Installation should only be performed by experienced technicians
under the consideration of DIN1988 and VOB.
- Before starting the installation, please stop the water supply
(ideally close the main valve at the water meter).
- Please make sure that during assembly all seals fit properly
(Always check - water damage possible)
- The fitting is suitable for use in private households and only in
rooms with a temperature above 0 ° C. If there are a risk of frost,
the water supply should be interrupted and the valve must be
completely emptied.
- Always before the first use and when a fitting has not been used
for a prolonged period, you should let rinse out a larger amount of
water (water stagnation) before drinking water is taken!
Important notes:
The product must be fitted to a solid wall or other firm surface. The
wall face must be flat. The installer should ensure that the nature
and construction of the wall will provide a firm fixing for all screws
supporting the product.uitgevoerd.
Operating conditions:
Hot water temperature
Test pressure
Operating pressure
Holding pressure for shower conversion min. 0.8 bar
(To keep noise level DIN 4109 pressure reducers have to be
installed
in the main line for pressures of more than 6 bar).
Reserve technical changes.
Care instructions:
Sanitary taps require special care. Please note the following information:
Chrome surfaces:
are sensitive for chemicals, acid-containing cleaning supplies and all
kinds of abrasives.
Occasionally clean with soapy water, using a soft cloth. Remove lime
deposits with household vinegar.
max. 80 ° Celsius
max. 16 bar
max. 10 bar
Werbung
