Lamax eJumper DB50 Benutzerhandbuch Seite 21

TROUBLESHOOTING
PROBLEM POSSIBLE CAUSE
Fuse blown due to overload
Loose wires or connectors
Non-functioning battery
Motorcycle will
not start
Uncharged battery
Damaged/failing switches or motor
Loose wires or connectors
Motorcycle starts,
but suddenly
Short circuit fuse activated
stops
Uncharged battery
Operating time
reduced
Old battery no longer at full capacity
Loose wires or connectors
Old battery no longer at full capacity
Motorcycle power
Motorcycle is overloaded
is weak
Driving conditions are too bad/difficult
Loose wires or connectors
Intermittent
operation
Damaged/failing switches or motor
Motor (gearbox)
is making loud
Damaged motor or gearbox
noises (clicking,
grinding, etc.)
Charger heats up
This is quite usual
while charging
NOTE
The table contains a list of the most common faults and how to resolve them. If you are not sure how to resolve
the issue or the issue can't be resolved, always contact an authorised service centre.
TECHNICAL AND CONSUMER INFORMATION
SERIAL NUMBER LOCATION
–
The serial numbers of the frame or motor are used to identify the vehicle. You will need this information when
ordering spare parts and when enquiring about technical details or warranty.
SERVICE AND SPARE PARTS
–
In the event of a malfunction, have this product repaired by an authorised service centre.
CORRECTIVE ACTION
Replace blown fuse with a new one.
Check and secure all wires and connectors.
An old or unmaintained battery can be
inoperable. Replace the battery with a new
one.
Charge the battery properly according to
the instructions.
Have it checked and repaired at an authoris-
ed service centre.
Check and secure all wires and connectors.
The fuse will stop the motorcycle if it is
overloaded, or if the driving conditions are
too extreme. The fuse must be manually
deactivated.
Charge the battery properly according to
the instructions.
Replace the battery with a new one.
Charge the battery properly according to
the instructions.
Replace the battery with a new one.
Do not overload the motorcycle, use it in
accordance with the operating instructions.
The motorcycle is designed for operation on
level ground. Do not operate in excessively
difficult terrain or in poor driving conditions.
Check and secure all wires and connectors.
Have it checked and repaired at an authoris-
ed service centre.
Have it checked and repaired at an authoris-
ed service centre.
No need to take any action
15