Kress KUE01 Bedienungsanleitung Seite 10

OPERATING
INSTRUCTIONS
NOTE: Before using the tool, read the
instruction book carefully.
Intended Use
The machine is intended for sawing wood, plastic,
metal and building materials while resting firmly on the
workpiece. It is suitable for straight and curved cuts.
ASSEMBLY AND OPERATION
ACTION
Tool-Less Blade Fitting
On/Off Operation
NOTE: LED light will illuminate the
working zone automatically when the
product is switched on.
NOTE: Your saw is equipped with
a lock-off button. Press the lock-off
button to lock the trigger switch.
Always lock the trigger switch when
carrying or storing the machine.
Variable Speed Control
HAND GRIP AREAS
FOOTPLATE ADJUSTMENT
10
NOTE: Adjust the position of footplate
according to the blade length and
EN
workpiece thickness; always ensure
that the blade extends beyond the
workpiece throughout the stroke.
PENDULUM SELECTOR KNOB
Adjust the pendulum speed according
to the workpiece material and
thickness.
OFF position: Fine cuts in thin
workpieces; cutting surface quality
is more preferred than speed; cutting
metal.
ON position: Fast cuts in soft materials
(e.g. softwood); cutting in the direction
of the wood grain.
Flush Cutting
Wood Cutting
Metal Cutting
Plastic / Aluminum Cutting
Pocket Cutting (Soft Materials Only)
WORK HINTS FOR YOUR
RECIPROCATING SAW
If your power tool becomes too hot, set the speed to
maximum and run a no load for 2-3 minutes to cool the
motor.
Always ensure the work-piece is firmly held or clamped
to prevent movement.
The blade guard must be held firmly against the
material being cut to reduce saw vibration, blade
jumping and blade breakage.
MAINTENANCE
FIGURE
Remove the battery pack from the tool before
See Fig. A
carrying out any adjustment, servicing or
maintenance.
Your tool requires no additional lubrication or
maintenance.
There are no user serviceable parts in your power
tool. Never use water or chemical cleaners to clean
See Fig. B1
your power tool. Wipe clean with a dry cloth. Always
store your power tool in a dry place. Keep the motor
ventilation slots clean. Keep all working controls free
of dust. Occasionally you may see sparks through the
ventilation slots. This is normal and will not damage
See Fig. B2
your power tool.
See Fig. C
FOR BATTERY TOOLS
See Fig. D1,
The ambient temperature range for the use and storage
D2, D3
of tool and battery is 0℃-45℃.
The recommended ambient temperature range for the
charging system during charging is 0℃-40℃.
ENVIRONMENTAL
PROTECTION
See Fig. E
Waste electrical products must not be disposed
of with household waste. Please recycle where
facilities exist. Check with your local authorities or
retailer for recycling advice.
See Fig. F, G
See Fig. H
See Fig. I
See Fig. J
See Fig. K