Additional Information - EMAG Emmi Bedienungsanleitung

5. Usage contrary to regulations
If the product is used contrary to the regulations, both danger to life and limb and damage to property can occur. For this reason, any use contrary
to the regulations is prohibited. If the product is not used for its intended purpose, the seller assumes no liability for any damage that may occur
and no guarantee that the components will work properly and function properly. In order to rule out improper use of the device, the following
instructions must be observed:
• The unit may only be operated with the mains voltage that is specified printed on the type plate.
• Do not use flammable or aggressive chemicals (acids, etc.) for cleaning.
• Before cleaning the device, make sure to pull out the power plug and let the device cool down.
• Do not connect the unit if transport damage is detected.
• To fill the unit with water, unplug the power plug and make sure that the unit is not placed in water and
no water penetrates the slots in the bottom of the unit.
• The device may only be operated indoors and in a dry environment.
• The device must not be placed in the hands of children!
• Do not remove the lid during operation and do not reach into the room disinfector!
• For optimal effectiveness, a cleaning brush is included with the device with visible adhesions
can be removed at the central ultrasonic transducer and in the equipment tray.
6. Mounting accessories
Please note that the device can only be operated properly with the float in place. Please make sure that
the device is switched off, the power plug is pulled out and the device has cooled down
1.) Disconnect power plug
2.) Remove cover and insert
3.) Separate the float basket by turning it clockwise
4.) Insert one float as shown (second and third float are optional as replacement)
5.) Attach the float basket to the cover by turning it to the left and put it back into the device
6.) Please fill up with water to below the MAX line.
7. Cleaning Information
It is recommended to remove regularly developing lime deposits. Clean the appliance with water or
gentle cleaning agents using a sponge or cloth. Do not use any substances containing solvents,
scouring agents or sharp objects.
8. service and maintenance work
IMPORTANT!
1. Check the device for damage. Do not use the appliance if there is any damage.
2. If the device has been exposed to icy temperatures (due to transport), it may only be operated after
30 minutes at room temperature.
3. To prevent damage to the room disinfector, it should not be operated without water. The device and
supply line must not be immersed in water. The device should be operated with dry fingers.
4. ATTENTION! Do not reach into the water when operating the device. The ultrasonic sensor can
become hot during operation. There is a risk of injury if you do not follow the instructions!

9. Additional information

Scent oil can be added to the designated container.Please note that only water is used to fill the device
so that no damage is caused to the device.
3