Werbung
Verfügbare Sprachen
Verfügbare Sprachen
QUICK GUIDE
Installing the mains power cable on the Ultronic
3.3 Installing the power cable
WARNING Electrocution
Charge-bearing internal capacitances can cause
electrocution if the mains plug contacts are touched.
f Install the discharge resistor.
f
Note
The mains power cable is supplied with a plug for a
standard socket.
f Ensure that the socket is easily accessible once the
f
appliance has been installed.
1 Discharge resistor
f Lay the appliance on its back.
f
f Install the discharge resistor between the L and N
f
contacts.
f Attach the brown wire to the L contact on the terminal
f
strip.
f Attach the blue wire to the N contact on the terminal strip.
f
f Attach the green and yellow wire to the PE contact on the
f
terminal strip.
f Tighten the screws on the terminal contacts.
f
Material losses
!
f Position the wires in such a way that they do not
f
hinder fitting of the casing cover and do not get
damaged.
STIEBEL ELTRON GmbH & Co. KG | Dr.-Stiebel-Str. 33 | 37603 Holzminden | info@stiebel-eltron.de
4 |
3.4 Wall mounting
f Observe the information in the operating and installation
f
instructions for the hand dryer (see chapter "Installation /
Wall mounting").
f Drill the 4 holes and insert rawl plugs.
f
f Screw the two lower fixing screws into the wall using the
f
wall spacers, as shown in the illustration.
f Position the appliance with the keyhole eyelets on the
f
fixing screws.
1
f Secure the appliance to the wall with the 2 upper fixing
f
screws and wall spacers, as shown in the illustration.
f Tighten the 4 fixing screws.
f
3.5 Assembling the casing cover
f Observe the information in the operating and installation
f
instructions for the hand dryer (see chapter "Installation").
317232-38386-8974
Werbung
