Cleaning The Condenser - Beko DF8412TAMM Bedienungsanleitung

6.4 Cleaning the Condenser

Small amount of lint may pass through the lint
filter and be collected on the metal surface of
the condenser.
Condenser metal surface needs to be cleaned
regularly.
If the evaporator icon is flashing on the display,
please inspect the metal surface of the
condenser. If it is dirty, clean it. This part should
be checked at lease once every 6 months.
C
NOTE
• Brush is inside the printing materials bag.
You can place it in its housing on the air
routing cover after the first usage.
46
• Open the toe
board by pressing
on it.
• To open the air
routing door, move
the release latch.
• Pull the brush to
the left side and
remove it. You can
use the cleaning
brush for removing
collected fluff on the
metal surface of the
condenser.
A
WARNING!
• You can clean by hand, provided you wear
protective gloves. Do not try to clean with
bare hands. Condenser fins may damage
your hands. Cleaning by the left to right
movements may damage the condenser
fins. This may lead to drying issues.
• Collected fluff
on condenser
surface should
be removed by
a damp cloth or
rubbing the brush
placed on the air
routing cover up
and down on the
condenser.
• Please do not
clean condenser
fins in right-left
direction to avoid
damage.
• You can also use
a vacuum cleaner
with a brush
for cleaning.
Condenser
cleaning is not
recommended
with a brushless
vacuum cleaner.
• Insert the brush
into its slot pushing
to the right, after
cleaning condenser,
front cover and lint
filter.
• After the cleaning
process is
completed, place
the air router door
to its place, move
the latches to close
it and close the toe
board.
Dryer / User Manual