GRE AR1009W Bedienungsanleitung Seite 3

EN
INSTALLATION
• Find a sunny outdoors location with easy access to the water supply and drains;
• Drill 4 holes of 8mm diameter and 35mm deep on the ground.
• Fix the solar shower vertically on the ground with 4 screws and screw nuts. (screw sizes: ø5×40mm);
Very important to include the seal ring and put A throughly into D!
• Once the shower has been completely installed, connect the water supply (with the adapter if neces-
sary), and turn the handle to on position to let the water in.
• When the tank is full of water, a few drops may come out of the shower head. You can then turn the
handle to off position.
• When the water has been warmed by sun heat, there might be some water drops falling through the
shower head. This is the usual phenomenon caused by the increased volume of water inside the tank
as the temperature rising.
• Also, it is normal that a few drops may leak on and off from the shower head for a while after you
finish shower.
PVC SOLAR SHOWER INSTRUCTION