Dust Extraction - Eibenstock EMF 125.2 Originalbetriebsanleitung

Information on Structural Calculations
Slots in supporting walls are subject to the Standard DIN 1053 part 1, or
country- specific regulations. These regulations are to be observed under all
circumstances. Before starting work, consult the responsible structural
engineer, architect or the construction supervisor. The permitted slot depth
and width depends on the slot length, wall thickness and the building
material used.

Dust Extraction

Dust which occurs during your work is hazardous to health. That is
why the EMF 125.2 must be used with a vacuum cleaner, and a dust
mask has to be worn. We also recommend the use of an anti-static
hose. This prevents
The suitable Wet/Dry Vacuum Cleaner DSS 25 M / DSS 35 M iP is available
as accessory. It can directly be attached to the connection on the dust hood.
Fig.7
Fig.8
Fig.9
When insert the suction
hose pull the ring of the hose fixing and turn the nozzle till the fixation
engages.
electrostatic charging
The suction hose can be locked against
slipping out by means of the hose fixing.
Make the necessary drill hole as follows:
Put the suction hose in the connector of the
hood.
Mark the plug-in depth with a crayon.
(see arrow)
Drill 13 mm from this marking (line) a hole with
diameter 6 mm in the nozzle.
24
from occurring.