Fastening Converter With Velcro - Pfeiffer Vacuum CONVERTER Betriebsanleitung

Installing converter with holding bracket on HiPace
1. Fasten the holding bracket with the cylinder screws to the vacuum pump.
2. Fasten the converter to the holding bracket with the components of the respective mounting kits.
Fig. 9:
1 Cylinder screw
2 Oval head screw
Installing converter with holding bracket on HiLobe
1. With the countersunk screws, fasten the holding bracket to the vacuum pump.
2. Fasten the converter to the holding bracket with the components of the respective mounting kits.
5.4 Fastening converter with Velcro
Damage due to incorrect installation materials
Incorrect screws and installation material can damage the device.
► Use only the installation materials supplied (in particular screws).
This type of attachment applies to installation on Pfeiffer Vacuum multi-stage roots pumps in series 4
and A 200 L V3.2.
– Tightening torque: 2.9 Nm
– Tightening torque: 1 Nm
1
2
3
Holding bracket installation – HiLobe converter
3
4
– Tightening torque: 1.2 Nm
– Tightening torque: 1 Nm
Support
Converter with installed holding bracket for HiLobe
NOTICE
Installation
4
29/36