Warning; Troubleshooting - Philips FR996/00S Bedienungsanleitung

WARNING

Under no circumstances should you try to repair the
set yourself as this will invalidate the guarantee. Do
not open the set as there is a risk of electric shock.
PROBLEM POSSIBLE CAUSE
No sound VOLUME is not correctly adjusted.
Headphones are connected.
The wrong source is selected.
No sound on the One speaker is wrongly connected.
left or right side
A speaker cable is damaged.
Volume balance in the receiver menu is
wrongly adjusted.
Poor sound or no sound at SURROUND mode is not switched on.
the center or surround
speakers
Surround and/or center speakers are not
(properly) connected.
Surround and/or center speakers are switched Set speaker present to YES.
off in the SPEAKR SETUP menu.
A speaker cable is damaged.
Poor bass sound Speakers are not in phase.
Bad sound Badly matching setting for the given type of
music or sound.
Surround sound level is The level of the surround sound is not
too low or too high properly adjusted.
Center sound level is too The sound level of the center channel is not
low or too high properly adjusted.
Only center speaker is A mono signal is reproduced.
heard in Dolby Surround
Pro Logic
Bad radio reception, Receiver or antenna is positioned near a
automatic programming radiation source such as a TV, CD player,
does not work properly CD recorder, DVD player, etc.
No digital recording The sampling frequency is not accepted by
possible via digital output the digital recorder.
Whole recording appears The DVD player does not provide track
as one track when information.
recording from DVD disc
All manuals and user guides at all-guides.com

TROUBLESHOOTING

If a fault occurs, first check the points listed, before taking
the set for repair.
If you are unable to solve a problem by following these hints,
consult your dealer or service centre.
SOLUTION
Adjust the VOLUME.
Disconnect headphones.
Turn SOURCE SELECT to select the correct
source.
Connect the speaker properly.
Replace the cable.
Adjust VOL FRONT-L and VOL FRONT-R
in the receiver menu.
Press SURROUND ON/OFF to switch on the
surround sound.
Connect the speakers properly.
Replace the cable.
Connect the coloured (or marked) wires to the
coloured terminals and the black (or unmarked)
wires to the black terminals.
Correct the sound settings on the receiver.
Adjust the level of the surround sound on
the receiver.
Adjust the level of the center channel
on the receiver.
Choose a different sound source or switch off
surround sound.
Change the position of the interfering unit
or try to switch it off.
Make sure the digital recorder can handle
sampling frequencies between 32 kHz and 48 kHz
or make the recording via analogue output.
Record each track individually or use the
"manual track increment" feature on the recorder.
25