Ozone Shield Bedienungsanleitung Seite 2

EN
THANK YOU FOR CHOOSING AN OZONE HELMET!
The OZONE Shield helmet offers high levels of protection, safety and
comfort and is CE certified for free flight. This manual offers useful advice
and important information regarding the use and maintenance of your
helmet.
FITTING / ADJUSTMENT
The Shield is available in one size and is fully adjustable to most head
sizes.
To put on the helmet, hold the side straps and pulling the ear pieces
slightly apart place the helmet on your head. The helmet should be seated
completely on your head with the front sitting just above your brow. Try to
rock it back and forth and twist it side to side, if you can easily move the
helmet on your head tighten the head strap using the adjustment system at
the rear. The chin strap has been designed to grant you the highest levels
of safety and comfort. Ensure that the buckle is correctly fastened and that
the chin strap is a tight fit under chin - but not so tight that it restricts your
jaw movement or breathing. Further adjustment to the angle of the chin
strap can be made with the side strap dividers near the ear piece.
A correctly fitted helmet should be comfortably snug and should pull the
skin on your forehead as you try to move it around.
It is extremely important to wear the helmet correctly, it should be
positioned on the head so that it protects the forehead, make sure it is
not pushed too far to the back of the head. Ensure the helmet is placed
on the head the correctly, wearing the helmet the wrong way round will
not only seriously reduce its protection capabilities, it will also make you
look stupid.