X-10 REX-10 Betriebsanleitung Seite 6

Note: the key chain remote normally controls X10 codes A1 to A4.
To change the key chain's House Code
•
Press and hold the first (top) ON button. The red LED blinks once. 3 seconds
later, the LED blinks the current setting: 1 blink for House Code A, 2 blinks for
B..... 16 blinks for P.
•
Release the first (top) ON button.
•
Press and release the first (top) ON button the appropriate number of times
for the House Code you want to set. Once for A, twice for B, etc. The LED
blinks for each press.
IMPORTANT: Hold the button on your last press. 3 seconds later, the red LED
blinks back the new setting, e.g. 3 blinks for House Code C. If you do not follow
this programming sequence, the LED will stay on for 1 second and your existing
setting will not be changed.
To change the Unit Code for the key chain's remote (the second pair of
buttons are always one # higher than the first pair, i.e. if you set the first button to
6, the second button controls 7, etc.).
•
Press and hold the top OFF button. The red LED blinks once. 3 seconds later,
the LED blinks the current setting: 1 blink for Unit Code 1, 2 blinks for 2, 16
blinks for 16.
•
Release the top OFF button.
•
Press and release the top OFF button the appropriate number of times for the
Unit Code you want.
IMPORTANT: Hold the button on your last press. 3 seconds later new code blinks
back. If you do not follow this programming sequence, the LED will stay on for
1second and your existing setting will not be changed.
To change the battery: Pry the unit apart and fit a CR2025 Lithium 3V battery.
Observe polarity. You will also need to change the code that Barking Dog
responds to; see To change Barking Dog's default setting of A1.
NOTE: NO CHANGES OR MODIFICA TIONS MAY BE MADE TO THE UNITS.
ANY CHANGES MADE TO THE UNITS WILL VOID THE USER'S AUTHORITY
TO OPERATE THE EQUIPMENT.
REX-10 BARKING DOG