Werbung
•
Press of the function key six times repeatedly to activate the menu. Here the language setting,
temperature unit, automatic switching off and the infobar can be changed.
The following options can be selected:
Language
[English, German, Français, Español, Nederlands]
»
Temperature units
[°C, °F]
»
Automatic switching off
[Off , 3Min., 5Min., 10Min.] – determines the lenght of down-
»
time, after which switch off automatically. Downtime is the period during which the function
key is not pressed. If the automatic switch off function is adjusted to „off ", the equipment can
only be switched off manually.
The infobar [1sec, 2sec, 4sec] – determines the refreshing rate of the values in the infobar.
»
In order to make changes, the desired option is to be selected with a click. Press the key for approxima-
tely 2 seconds, until the selected option begins to fl ash and becomes active. Press the key for another
2 seconds to deactivate the function. In order to get out of the setup menu and back into the measuring
mode, select SAVE & EXIT, then keep the key pressed for 2 seconds.
The following pictures show the described procedure.
5
CAISSON ELEKTRONIK GmbH
Boschstrasse 16, D-47533 Kleve, Deutschland
T: +49 (0) 2821-894390
info@caisson-gmbh.de www.caisson-gmbh.de
Press the function button
Press the functions button 5 times
Press and hold the function button for 2 seconds
Switching - off the device
•
In order to switch the device off , press and hold the function key for approx. 6 seconds. It cannot
be done from the setup menu.
•
The measuring can switch off automatically; if the function for automatic switching off is active
(see section menu of the device).
•
If the battery charge is so low that in fact it could negatively aff ect the measurement the device
will automatically switch off , which is signalled earlier with the message „battery empty".
Practical hints
The air fl ow through the cover of the sensor
•
The air humidity and air temperature sensor are
behind a plastic screen that should not be covered
or else free air circulation will be obstructed and
measurements rendered inaccurate.
•
The air humidity and air temperature sensor needs
time, in order to adapt to new measuring conditions.
Wait 2 minutes prior to activating the device. This
time can be shortened by gentlye moving the devi-
ce, which will force the air fl ow across sensor cover.
•
The device can also measur the dew point. If the
temperature of the assistance of a thermal element checked surface is lower or very similar to the dew
point temperature, then condensation of water on the surface occurs, which is signalled acoustically
and visually.
CAISSON ELEKTRONIK GmbH
Boschstrasse 16, D-47533 Kleve, Deutschland
T: +49 (0) 2821-894390
info@caisson-gmbh.de www.caisson-gmbh.de
Werbung
