Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
| EN |
WARNING
SAFETY INSTRUCTIONS
The transmission jack is used for removing, moving and installation of gearbox, transmission
box, drive axle or other workpieces.
The transmission jack can only be operated and used by person trained or familiar with this
operation manual.
The weight of the workpieces to be removed, moved or installed should never exceed the
rated capacity of the transmission jack and those of its accessories, and the lifting height should
never exceed the maximum stroke of the jack that is indicated on the label.
This transmission jack can only be supported on a solid, level and horizontal surface that can
withstand the load.
Make sure the vehicle is adequately supported and secured before starting maintenance.
Avoid any eccentric placement of workpieces, which may cause overturning or damage of
workpieces and transmission jack.
During transportation, please ensure that the piston rod is lowered to the lowest position and
the workpiece is placed stably.
Please do not modify the transmission jack in any way, and do not change the safety valve
under any circumstances.
Non-compliance with these instructions may result in injury or damage to the user, the
transmission jack or the workpiece in the operation.
The manufacturer accepts no responsibility for the improper use of the transmission jack or the
damage to the workpiece caused by this improper use.
Lower to the lowest position
Do not use on inclined
Do not place eccentrically
during transporting.
and uneven ground
Werbung
Inhaltsverzeichnis
