Casselin CPAI500B Bedienungsanleitung Seite 16

All manuals and user guides at all-guides.com
If the induction stove recognizes too large a difference in magnetic field, a drop in power occurs. This may
EN
cause the safety lock to operate, thus preventing the device from overheating. Therefore, avoid using
aluminum, bronze or non-metallic containers.
1. ON / OFF button
2. Heating / temperature / timer mode
3. Adjustment knob
SETTING
Plug in the electrical outlet.
Place the saucepan in the center of the stove, and press the ON / OFF key (pos. 1) to switch on the appliance,
the digital screen will light up.
Press the FUNCTION button (pos. 2) until the HEATING indicator light appears on the control panel in order
to set the desired power. It can vary from 500 to 3500 W by turning the knob clockwise. The default power is
2000 W.
Press the FUNCTION button (pos. 2) until the indicator light is on TEMP on the control panel in order to set
the desired temperature from 60 ° C to 240 ° C by turning the knob clockwise. a watch.
Press the FUNCTION button (pos. 2) until the TIMER indicator light appears on the control panel in order to
set the desired time delay from 0 to 180 minutes by turning the knob clockwise .
The induction stove will automatically turn off if there is no operation within 2 hours.
The temperature of accessible surfaces may be high when the appliance is in operation.
The device is not intended for permanent industrial use.
INDICATION
During operation, you can change the timer setting at any time using the selection keys and. Thanks to the
device memory, the power level or temperature setting remains unchanged. The same method can be used
to change the power or temperature mode without changing the timer setting. The device will then operate
according to the parameters entered last.
NOTE
The device is fitted with a safety system in the event of overheating. If tripped, unplug the device and allow it
to cool. If this protection system operates regularly, it is imperative to contact our after-sales service or your
dealer.
After automatic shutdown, the device can only be put into service by pressing the Reset button on the back
of the device, wait for the oil temperature to drop, then unscrew the plastic protection by turning anti-
clockwise, press the reset button then screw the plastic protection back on.