Operating Instructions; How To Use - Auvon AS8012C Bedienungsanleitung

4.OPERATING INSTRUCTIONS

HOW TO USE

1. Clean your skin before use. Use the pads on clean and
flat areas, no sweat, no oil.
2. Attach one pair or two pairs of the electrode pads to the
massager area, such as shoulder and leg.
Note: Adding a few drops of water on the pads and drying
the pads naturally will increase their longevity. Make sure
both pads on the skin and not overlapping.
3. Connect a pair of electrode pads to one lead wire by plug
them on; the other end of the wire is connected to the left
output of the device. Similarly, the other pair of electrode
pads is connected to the remaining wire end and the right
output of the device.
4. Turn on the device by sliding the on/ off switch on the top
of the unit.
5. Press the left " V " or "
"starts to flash. (Or Press the right " V " or "
Channel B, then " B " starts to flash.)
6. Press the " M " button to choose 6 master modes, and
press the " < " and " > " button to choose sub-modes. If " A "
are flashing, the mode chosen is for channel A. (If " B " are
flashing, the mode chosen is for channel B).
7. Press the left " V " or "
the strength of channel A. Press the right " V " or "
increase or decrease the strength of channel B.
Note: Remember the strength will default to the lowest
setting by each mode selection.
Support@iauvon.com
" to choose Channel A, then " A
" to increase or decrease
17
" to choose
" to
UK