Eurotops C7393 Bedienungsanleitung Seite 7

C7393 / JB7593
BATTERY CHARGING STATION W/USB
Warning: Please read this instruction manual carefully before using the
instrument and keep it for future use.
Important Safety Instructions:
•
Remove batteries promptly when fully charged. Overcharging may cause batteries
to burst exposing surfaces to corrosives acids.
•
Do not use an extension cord. It could cause a fire or electric shock.
•
Do not charge damaged, rusted or leaking batteries.
•
Do not use near water, flames or fire.
•
Always unplug the Battery Charger and Tester after charging or testing is complete
and before removing the batteries.
•
The device is intended exclusively for private and not for commercial use. Only use
this device as describe in this instruction manual.
•
Before to use, make sure that the supply voltage corresponds with the voltage
marked on the rating label.
•
Do not place any part of this appliance in water or any other liquid.
•
Do not leave the device unattended when plugged in.
•
Do not handle the unit or plug with wet hands.
•
Unplug from the power outlet after use and allow the appliance to cool down
completely before to clean it or to move it.
•
When disconnecting the cable, always pull at the plug; do not pull on the cable
itself.
•
When using the device, always pull the power cord completely from its housing to
prevent overheating.
•
If the cord is damaged, it must be replaced by the manufacturer or its service agent
or a similarly qualified person in order to avoid an electric shock.
•
Never try to repair it by yourself. It must be repaired by the manufacturer or its
service agent or a similarly qualified person in order to avoid an electric shock.
•
The power cable must be checked regularly to avoid damage. If the power cable is
damaged it must be replaced by a qualified service center to avoid any danger.
•
Always place your device on a dry surface.
•
EN Do not use outdoors.
•
Do not let the power cord on the edge of a table or work surface, and prevent it
comes into contact with hot surfaces.
•
Keep it away from heat sources such as radiators, to avoid deformation of plastic
parts.
•
Do not touch the hot surface. Keep the appliance out of reach of children.
•
The unit must be cleaned regularly to avoid the risk of fire.
•
Do not use coarse or abrasive sponges/cloths or steel wool to clean the appliance.
•
This unit is not designed to be operated by means of an external timer or a separate
remote control system.
Operation:
General Charging Recommendations
•
It is normal for the batteries to become warm while charging.
•
Charge batteries in an area between 32° and 80°F (0° and 27°C). Cold batteries
cannot charge fully. If the area is too warm, the batteries can permanently lose their
ability to charge.
•
There will be a buzzing sound if the battery is damaged or incorrectly installed.
•
Ensure you load the batteries in the chambers as indicated by the polarity symbols
(+/-). Remove batteries promptly.
•
Overcharging may cause batteries to burst.
Light Status Indicators
•
While a battery is charging, the LED Display will indicate the
current amount of charge of the battery.
•
When the battery is close to being fully charged, the
corresponding bar will flash.
•
Once the battery is fully charged, all bars will be displayed full without flashing. The
duration of this state will vary depending on the battery capacity and type. You may
continue charging to ensure the batteries are fully charged, however DO NOT
exceed 4 hours at this state as this may damage the unit and the batteries.
Compatible with:
•
IT IS RECOMMENDED TO USE THE CHARGER WITH QUALITY
NAME BRAND RECHARGEABLE ALKALINE BATTERIES
•
Battery type: standard, heavy duty, alkaline, Ni-Cad and NI-
MH, Rechargeable Alkaline, Zinc-Carbon and High Powered
batteries.
•
Battery Size: AAA, AA, C, D, 9V and 12V