General Remarks - ADB M 7010 Bedienungsanleitung

HF / LF 1000
Advice before Use
• Read carefully these instructions.
• As soon as the equipment is delivered, open packings and inspect
the equipment carefully.
If you notice any damage, contact immediately the transport
company and register your complaint in due form with mention of
the defects.
Be sure that this equipment left our factory in perfect condition.
• Check if the received equipment is consistent with the delivery
notice and if this delivery notice is consistent with your order.
If it is not, contact immediately your supplier.

General Remarks

This luminaire is a lighting equipment designed for professional use
only in theatres and indoor television or movie studios.
Designed and built in accordance with EN 60598-1 and EN 60598-2-17
safety regulations, it must imperatively be connected to earth by means
of its earth wire.
To prevent any electrical shock, there is no need to open this equipment
when functioning.
Nevertheless:
• Lamp must be changed if damaged or distorted by heat.
If internal access is needed for control, service or repair purposes,
always refer to qualified personnel.
In all events, always unplug the power supply cable before opening,
LETHAL VOLTAGE PRESENT INSIDE
It is the user's responsibility to use the luminaire for its intended
purpose and to check the equipment that might be connected to
it.
The luminaire can under no circumstances be modified.
ADB will not assume any responsibility in case of damage resulting
from modications made to the luminaire.
This luminaire is a piece of professional equipment designed for
easy and simple use. Nevertheless, always refer to qualified
personnel for any installation or repair work.
I
mportant Remark
Power supply cables and other connections are essential for your
equipment and contribute greatly to a safe and trouble free operation.
• Always hold the plug when disconnecting a cable, never pull the
cable.
• Never use cables or connectors in bad condition, check them
before installation and periodically thereafter.
• Never tie power supply and data cables together.
Page 6
Spotlight Description
1 Screws for the assembly of the vertical barndoors.
2 Locking lever.
3 Suspension yoke.
4 Screws for the assembly of the horizontal barndoors.
5 Lateral slides for the safety grille or the filter frame.
6 Socket of the lamp.
7 Reflector.
8 safety grid.
The index plate, which is located on the rear surface of the equipment,
states the following details
1 maximum tilt of luminaire allowed 0° position
2 symbol indicating minimum distance (in m) between inflammable
matters and any external part of the luminaire to prevent ignition of
inflammable matters from 80°C up
3 maximum permissible ambient temperature (in °C) for normal
operation
4 weight without lamp and accessories (in kg)
5 resistance luminaire IP (International Protection) protection index
defining to dust and humidity
6 code number
7 maximum wattage (in W) of the lamp
8 maximum permissible current in A
9 maximum temperature (in °C) of the luminaire housing during
normal operation
10 maximum temperature (in °C) to which the supply cable will be
submitted
11 rated power supply voltage in V
12 lampholder type
13 serial number
14 indication of the luminaire's top side
Fitting the lamps
ALWAYS disconnect the supply cable from the mains.
Please refer to the index plate to establish the type of lamp to be used.
Please consult the manufacturer's instructions supplied with the lamp
so as to use the lamp in the proper manner.
The lamp MUST be replaced if it has been damaged or deformed by
heat.
Remove the safety grid or the filter frame.
Place the lamp into the socket.
Replace the safety grid or the filter frame.
Lighting Technologies