Setting The -5 Khz Carrier Offset In Ru Mode - stabo xm 3004e VOX 12/24 Bedienungsanleitung

Changing the sensitivity:
Switch on VOX by pressing the VOX key once. VOX flashes.
Now press the F key once, F and VOX will flash.
Press the VOX key again once and the level set will be displayed.
Select the desired level (L1 (high sensitivity = low threshold) to L5 (low sensitivity = high
threshold) using the channel switch or the UP/DN keys.
Save the setting by pressing the PTT key until you hear a beep.
The sensitivity setting depends on the volume of your voice, the positioning of the microphone
and the ambient noises.
In order for VOX to work you must set squelch correctly or switch on ASC.
Open squelch or ASC blocks VOX while a signal is being received and the VOX display
flashes.
VOX is reactivated after approximately one second once squelch or ASC has been closed.
This prevents unintentional transmissions caused by the reception signal.
The activated VOX function can only transmit if squelch or ASC is activated.
MODE (5)
Modulation types AM/FM
In program positions 40/40 and 80/40 you can operate in both FM and AM. Your preferred
modulation type of the two depends on your conversation partners and your own
requirements. However, bear in mind that there is compulsory registration for AM operation in
many countries!
In general, frequency-modulated signals (FM) are less sensitive to interferences from ignition
sparks etc. than amplitude modulated signals (AM). If you hear an unintelligible, distorted
sounding signal in the speaker, it is advisable to try to receive using another modulation type.
To change the modulation type, press the MODE key 5 once. The modulation type is shown
on the display screen as AM or FM. Switch between AM, FM and FM UK in frequency band U.
ANL ) (5)
(Automatic Noise Limiter
The device is equipped with an automatic noise limiter.
Press and hold the MODE key 5 to switch the ANL on/off. ANL is shown on the display screen
when it is activated.
Note: The ANL only works in AM mode.
EMG (8)
To change the EMG configuration, press the EMG key once, then the EMG is shown in the
display.
Then press and hold the EMG key, EMG flashes and F is also displayed.
Now select the desired channel with the channel switch or the UP/DN keys and select the
desired modulation type by pressing the MODE key.
Press the PTT button once to save the setting. The acoustic signal confirms this.
To change the second EMG configuration, proceed in exactly the same way.

Setting the -5 KHz carrier offset in RU mode

In RU (rU) mode, T0 (t. 0 ) is the standard setting.
To enter the carrier offset setting, press and hold the F key until T5 (t5) appears, then release.
To return to the standard setting, press the F key again until T0 (t. 0 ) appears, then release.
22